Aiwa
n00b
Joined: 11 Jul 2004
Posts: 8
|
 Posted: Sat Jul 31, 2004 12:17 am Post subject: Unable to set up ISDN |
 |
|
Hello,
I just spent a day trying to set up Linux on my AMD64 Gentoo box. I mainly followed this guide:
https://forums.gentoo.org/viewtopic.php?t=29991
My ISDN card is a US Robotics ISDN PCI Card TA, model nr. USR133409. Since the card uses a Winbond 6692 chip, I picked that one in menuconfig, along with the other HiSax and ISDN4Linux stuff mentioned in the tutorial.
Despite all my efforts, there seems not to be any ISDN or ppp devices in /dev. The initialization scripts fail and alternative configurations via /etc/conf.d/net fail as well, all statting unknown device, device not found etc.
The kernel compiles fine, but since Kernel 2.6.7 my bootlogging is screwed so compiled with HiSax as a module to read the log from modprobe.
modprobe hisax type=36
produces the following...
| Code: |
Jul 31 02:01:20 Aiwa-Server HiSax: Linux Driver for passive ISDN cards
Jul 31 02:01:20 Aiwa-Server HiSax: Version 3.5 (module)
Jul 31 02:01:20 Aiwa-Server HiSax: Layer1 Revision 2.46.2.5
Jul 31 02:01:20 Aiwa-Server HiSax: Layer2 Revision 2.30.2.4
Jul 31 02:01:20 Aiwa-Server HiSax: TeiMgr Revision 2.20.2.3
Jul 31 02:01:20 Aiwa-Server HiSax: Layer3 Revision 2.22.2.3
Jul 31 02:01:20 Aiwa-Server HiSax: LinkLayer Revision 2.59.2.4
Jul 31 02:01:20 Aiwa-Server HiSax: Warning - no protocol specified
Jul 31 02:01:20 Aiwa-Server HiSax: using protocol EURO
Jul 31 02:01:20 Aiwa-Server HiSax: Total 1 card defined
Jul 31 02:01:20 Aiwa-Server HiSax: Card 1 Protocol EDSS1 Id=HiSax (0)
Jul 31 02:01:20 Aiwa-Server HiSax: W6692 driver Rev. 1.18.2.4
Jul 31 02:01:20 Aiwa-Server Found: U.S.Robotics ISDN PCI Card TA, I/O base: 0xc400, irq: 19
Jul 31 02:01:20 Aiwa-Server HiSax: ISDN PCI Card TA config irq:19 I/O:c400
Jul 31 02:01:20 Aiwa-Server W6692: Winbond W6692 version (0): W6692 V00
Jul 31 02:01:20 Aiwa-Server W6692 ISTA=0x0
Jul 31 02:01:20 Aiwa-Server W6692 IMASK=0xFF
Jul 31 02:01:20 Aiwa-Server W6692 D_EXIR=0x0
Jul 31 02:01:20 Aiwa-Server W6692 D_EXIM=0xFF
Jul 31 02:01:20 Aiwa-Server W6692 D_RSTA=0x20
Jul 31 02:01:20 Aiwa-Server Winbond 6692: IRQ 19 count 0
Jul 31 02:01:20 Aiwa-Server Winbond 6692: IRQ 19 count 4
Jul 31 02:01:20 Aiwa-Server HiSax: DSS1 Rev. 2.32.2.3
Jul 31 02:01:20 Aiwa-Server HiSax: 2 channels added
Jul 31 02:01:20 Aiwa-Server HiSax: MAX_WAITING_CALLS added
|
This looks fine according to the hisax readme.
lspci -v
shows:
| Code: |
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8385 [K8T800 AGP] Host Bridge (rev 01)
Subsystem: Asustek Computer, Inc.: Unknown device 80a3
Flags: bus master, 66Mhz, medium devsel, latency 8
Memory at f8000000 (32-bit, prefetchable)
Capabilities: [80] AGP version 3.5
Capabilities: [c0] #08 [0060]
Capabilities: [68] Power Management version 2
Capabilities: [58] #08 [8001]
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI bridge [K8T800 South] (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 0000a000-0000afff
Memory behind bridge: fc700000-fccfffff
Prefetchable memory behind bridge: b7f00000-f7efffff
Expansion ROM at 0000a000 [disabled] [size=4K]
Capabilities: [80] Power Management version 2
0000:00:08.0 RAID bus controller: Promise Technology, Inc. PDC20376 (FastTrak 376) (rev 02)
Subsystem: Asustek Computer, Inc. A7V8X motherboard
Flags: bus master, 66Mhz, medium devsel, latency 240, IRQ 18
I/O ports at b400
I/O ports at b000 [size=16]
I/O ports at ec00 [size=128]
Memory at fd800000 (32-bit, non-prefetchable) [size=4K]
Memory at fd700000 (32-bit, non-prefetchable) [size=128K]
Capabilities: [60] Power Management version 2
0000:00:0c.0 Ethernet controller: VIA Technologies, Inc. VT6105 [Rhine-III] (rev 86)
Subsystem: D-Link System Inc DFE-530TX rev C
Flags: bus master, medium devsel, latency 64, IRQ 17
I/O ports at b800 [size=fd900000]
Memory at fda00000 (32-bit, non-prefetchable) [size=256]
Expansion ROM at 00010000 [disabled]
Capabilities: [40] Power Management version 2
0000:00:0d.0 Token ring network controller: IBM 16/4 Token ring UTP/STP controller (rev 05)
Flags: bus master, medium devsel, latency 64, IRQ 18
I/O ports at c000 [size=fdb00000]
Memory at fdd00000 (32-bit, non-prefetchable) [size=256]
Memory at fdc00000 (32-bit, non-prefetchable) [size=2K]
Expansion ROM at 00004000 [disabled]
0000:00:0e.0 Network controller: Winbond Electronics Corp W6692 (rev 01)
Subsystem: U.S. Robotics: Unknown device 3409
Flags: medium devsel, IRQ 19
Memory at fde00000 (32-bit, non-prefetchable)
I/O ports at c400 [size=256]
0000:00:0f.0 RAID bus controller: VIA Technologies, Inc. VIA VT6420 SATA RAID Controller (rev 80)
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 20
I/O ports at e800
I/O ports at e400 [size=4]
I/O ports at e000 [size=8]
I/O ports at d800 [size=4]
I/O ports at d400 [size=16]
I/O ports at d000 [size=256]
Capabilities: [c0] Power Management version 2
0000:00:0f.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
Subsystem: VIA Technologies, Inc. VT82C586/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE
Flags: bus master, medium devsel, latency 32, IRQ 20
I/O ports at fc00 [size=16]
Capabilities: [c0] Power Management version 2
0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
I/O ports at c800 [size=32]
Capabilities: [80] Power Management version 2
0000:00:10.4 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 86) (prog-if 20 [EHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
Memory at fdf00000 (32-bit, non-prefetchable)
Capabilities: [80] Power Management version 2
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8237 ISA bridge [K8T800 South]
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, stepping, medium devsel, latency 0
Capabilities: [c0] Power Management version 2
0000:00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
Capabilities: [80] #08 [2101]
0000:00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
0000:00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
0000:00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
0000:01:00.0 VGA compatible controller: ATI Technologies Inc RV350 AQ [Radeon 9600] (prog-if 00 [VGA])
Subsystem: PC Partner Limited: Unknown device 7c20
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 16
Memory at e0000000 (32-bit, prefetchable)
I/O ports at a000 [size=256]
Memory at fcc00000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [58] AGP version 3.0
Capabilities: [50] Power Management version 2
0000:01:00.1 Display controller: ATI Technologies Inc RV350 AQ [Radeon 9600] (Secondary)
Subsystem: PC Partner Limited: Unknown device 7c21
Flags: bus master, 66Mhz, medium devsel, latency 64
Memory at d0000000 (32-bit, prefetchable)
Memory at fca00000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [50] Power Management version 2
|
Both with in-kernel compilation and modprobe there are no ISDN devices visible. lspci shows no hardware conflicts and the logfile seems perfectly okay. Any ideas? Note: My box is an Athlon 64, it might be an incompatibility issue. |
|
Networking & Security
