| View previous topic :: View next topic |
| Author |
Message |
jake_the_snake
n00b
Joined: 04 Nov 2005
Posts: 6
|
 Posted: Sat Nov 05, 2005 8:33 am Post subject: gentoo can´t find my networkcard |
 |
|
hola ok this is what it says when i have started gentoo
eth0 does not exist
and lower down it says ERROR: problem starting needed services. "netmount" was not found.
when i run with livecd the networkcard works fine. but when im done with the installation bit and reboot the networkcard is gone and dont work.
plz give a noob some help  |
|
| Back to top |
|
 |
raccoon
n00b
Joined: 28 Apr 2004
Posts: 36
Location: Wonderland
|
| Posted: Sat Nov 05, 2005 8:55 am Post subject: |
|
|
It seems to me that you don't have support for your network card enabled in the kernel. Do you know what card model you have? If not, load up the LiveCD and check which modules are loaded after boot.
_________________
Adopt an unanswered post! |
|
| Back to top |
|
|
jake_the_snake
n00b
Joined: 04 Nov 2005
Posts: 6
|
| Posted: Sat Nov 05, 2005 12:11 pm Post subject: |
|
|
well hmm i dont know how to check what modules that is loaded.
and i dont know what kinda card i use it doesent say on the card 
there hafto be a way to save the settings from when i use liveCD to installed gentoo or something.
god im a newb  |
|
| Back to top |
|
|
jake_the_snake
n00b
Joined: 04 Nov 2005
Posts: 6
|
| Posted: Sat Nov 05, 2005 12:35 pm Post subject: |
|
|
0000:00:09.0 Ethernet controller: Linksys NC100 Network Everywhere Fast Ethernet 10/100 (rev 11)
thats the name of it |
|
| Back to top |
|
|
EdtheRat
Tux's lil' helper
Joined: 17 Sep 2005
Posts: 113
Location: Germany - in the middle of nowhere!
|
| Posted: Sat Nov 05, 2005 1:11 pm Post subject: |
|
|
Hallo jake_the_snake!
You need the chipset fo your card, and not the name of the manufacturer.
lspci -vv Section: Ethernet Controller will continue to help?
_________________
LG
EdtheRat |
|
| Back to top |
|
|
|
Kernel & Hardware
