Heatsink mounting hole standard? (Gentoo install)

grant123 · Veteran Joined: 23 Mar 2005 Posts: 1099

Maybe not strictly a Gentoo question, but I'm planning to install Gentoo on this cutting edge ARM board (Jetson TK1):

http://www.newegg.com/Product/Product.aspx?Item=N82E16813190005

I'd like to replace the fan with a heatsink as discussed here:

http://elinux.org/Jetson/Jetson_TK1_Power#Replacing_the_fan_with_a_heatsink

These look like they would roughly fit the existing mount holes in the board:

http://www.digikey.com/product-detail/en/ATS-1040-C3-R0/ATS1406-ND/2688478
http://www.digikey.com/product-detail/en/ATS-1040-C2-R0/ATS1405-ND/2688477
http://www.digikey.com/product-detail/en/ATS-1040-C1-R0/ATS1404-ND/2688476

How can I be sure? Is there a mounting hole standard that the board and heatsinks are likely complying with?

defer- · Posted: Sat Jun 28, 2014 3:42 pm Post subject:

That computer looks nice but remember its nvidia.

Looks like the heatsink in picture would fit. If it doesnt use that "glue thermal paste" i dont remember what it was called.
_________________
https://github.com/defer-

grant123 · Veteran Joined: 23 Mar 2005 Posts: 1099

Is Nvidia still not open-source friendly? I thought they were coming around on that.

Support for this board is said to be going into nouveau.