rekby n00b
Joined: 06 Nov 2015 Posts: 1
|
Posted: Fri Nov 06, 2015 3:17 pm Post subject: Broadcom BCM4312, Acer AO751h |
|
|
Не могу настроить WiFi - ip link не показывает WiFi карту.
Попробовал поставить broadcom-sta по инструкции http://gentoo-en.vfose.ru/wiki/Broadcom_43xx и ndiswrapper.
Система 32-битная.
Code: |
lspci -nn
03:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g LP-PHY [14e4:4315] (rev 01)
uname -a
Linux elena 4.0.9-gentoo #6 SMP Fri Nov 6 14:33:39 Local time zone must be set--see zic m i686 Intel(R) Atom(TM) CPU Z520 @ 1.33GHz GenuineIntel GNU/Linux
ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
link/ether 00:26:9e:16:a7:db brd ff:ff:ff:ff:ff:ff
3: sit0@NONE: <NOARP> mtu 1480 qdisc noop state DOWN mode DEFAULT group default
link/sit 0.0.0.0 brd 0.0.0.0
lsmod
Module Size Used by
ndiswrapper 173692 0
b43 71316 0
mac80211 440967 1 b43
wl 6067759 0
cfg80211 400361 3 wl,b43,mac80211
ndiswrapper -l
bcmwl5 : driver installed
device (14E4:4315) present
Конфиг ядра:
cat .config | grep WIRE
CONFIG_WIRELESS=y
CONFIG_WIRELESS_EXT=y
cat .config | grep B43 | grep -v '#'
CONFIG_B43=m
CONFIG_B43_BCMA=y
CONFIG_B43_SSB=y
CONFIG_B43_BUSES_BCMA_AND_SSB=y
CONFIG_B43_PCI_AUTOSELECT=y
CONFIG_B43_PCICORE_AUTOSELECT=y
CONFIG_B43_BCMA_PIO=y
CONFIG_B43_PIO=y
CONFIG_B43_LEDS=y
CONFIG_B43_HWRNG=y
CONFIG_B43LEGACY=m
CONFIG_B43LEGACY_PCI_AUTOSELECT=y
CONFIG_B43LEGACY_PCICORE_AUTOSELECT=y
CONFIG_B43LEGACY_LEDS=y
CONFIG_B43LEGACY_HWRNG=y
CONFIG_B43LEGACY_DMA=y
CONFIG_B43LEGACY_PIO=y
CONFIG_B43LEGACY_DMA_AND_PIO_MODE=y
CONFIG_SSB_B43_PCI_BRIDGE=y
|
|
|