| View previous topic :: View next topic |
| Author |
Message |
sergent1977
n00b
Joined: 14 Nov 2003
Posts: 33
|
 Posted: Mon Nov 17, 2003 5:30 am Post subject: net not starting (nforce2 MB) |
 |
|
Hi,
Again me.
well this time there is a problem with the network
When I installed the first time gentoo I started from the stage 3 and did not do update the sources when installed
I had to reinstall everything from stage 3 again and decided (according to the manual) to add
CONFIG_PROTECT="-* /etc/make.conf" emerge -u system
And apparently something got changed because now when I start after the install I get a couple errors at the end.
| Code: |
*Starting USA and PCI hotplugging
Cannot get config descriptor 0 Broken Pipe (32)
*Bringing eth0 ip...
*eth0 is not plugged in or has no carrier signal
*Error problem starting needed services
*"netmount" was not started
|
I know for sure that eth0 is plugged in and has signal because I just installed everything
Also, my motherboars is a LEADTEK winfast K7NCR18G-PRO with the nvidia nforce2 chip and sound and graphic chip integrated.
Does someone has some tips...??????
Thanks a bunch.... |
|
| Back to top |
|
 |
sergent1977
n00b
Joined: 14 Nov 2003
Posts: 33
|
| Posted: Mon Nov 17, 2003 6:58 am Post subject: net not starting (nforce2 MB) unless dhcpcd |
|
|
Ok now the module loads properly
When I do lsmod I can see nvnet
But I still get the errors messages that I wrote before
However, if I do dhcpcd eth0
and then a ping, then the network is funcional
Moreover the file in /etc/conf.d/net contains
iface_eth0="dhcp"
So I think I am lost because I thought that iface_eth0="dhcp" was doing the same thing as dhcpcd eth0
So if somebody as a way to do automaticaly iface_eth0="dhcp" let me know
Thanks a lot |
|
| Back to top |
|
|
b0fh
Guru
Joined: 16 Jun 2003
Posts: 426
|
|
| Back to top |
|
|
sergent1977
n00b
Joined: 14 Nov 2003
Posts: 33
|
|
| Back to top |
|
|
|
Installing Gentoo
