usb flash driber under 2.6.0 kernel

[anhtran81]

Hi, I am using the new kernel with great pleasant. It seems running faster than 2.4 kernel and more responsive. BTW, I still have some problems with it. I used to have my usb flash drive working under 2.4 kernel using scsi-emulation. So Do i need to use it again with the new kernel and how

This is the output of dmesg:

hub 2-0:1.0: new USB device on port 1, assigned address 2
Initializing USB Mass Storage driver...
drivers/usb/core/usb.c: registered new driver usb-storage
USB Mass Storage support registered.
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: SigmaTel Model: MP300F Player Rev: 0100
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
usb 2-1: USB disconnect, address 2
hub 2-0:1.0: new USB device on port 1, assigned address 3
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: SigmaTel Model: MP300F Player Rev: 0100
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi generic sg0 at scsi1, channel 0, id 0, lun 0, type 0
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3
usb 2-1: USB disconnect, address 3
hub 2-0:1.0: new USB device on port 1, assigned address 4
scsi2 : SCSI emulation for USB Mass Storage devices
Vendor: SigmaTel Model: MP300F Player Rev: 0100
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi generic sg0 at scsi2, channel 0, id 0, lun 0, type 0
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 4
loop: loaded (max 8 devices)

Notice that how it change scsi from 0 then 1 and 2. And i try to mount them I got the error saying that is not a block device.

Any got similar problem please post the solution thanks

[snkmoorthy]

I have the same behaviour with a USB DVD-drive. Initial plug will give me

scsi - 0, 0, 0
second time 1,0,0 so on.

one could reset this if you unload the usb-modules and reload them, then you can start from 0,0,0.

you need usb-storage and other SCSI modules(same as CDRW used to be). To mount it will usually be /dev/sda1

so a mount like,