[SOLVED] Not getting a Framebuffer to use during boot

[vrghost]

Trying to install nvidia-driver (the proprietery one), and following this guide to the letter:
https://wiki.gentoo.org/wiki/NVIDIA/nvidia-drivers

However, when I reboot my machine, Grub (or what comes after grub) does not manage to use or find a framebuffer, so the last thing that is updated to the screen is EFI Stub:
The machine does continue to start, and I assume it is fully up and running (newly installed system, so I know I can ping it, and SSH to it, but I cant get to a terminal via SSH, as I get the following error message:
PTY allocation request failed on channel 1

I've tried to rebuild the kernel a few times, and I think I've singled out the issue, as soon as I turn of the Simple FB

[pietinger]

vrghost,

you can use wgetpaste ( https://wiki.gentoo.org/wiki/Wgetpaste ) for your kernel .config. Maybe check before if you have enabled "Framebuffer Console support" and "Enable legacy fbdev support"

(see here: https://wiki.gentoo.org/wiki/User:Pietinger/Tutorials/Manual_Configuring_Kernel_Version_6.6#Part_3_-_Must_Haves )
_________________
https://wiki.gentoo.org/wiki/User:Pietinger

[vrghost]

Amazing pietinger

Thank you so very much for that tip, should have checked that first

Also, I did notice that technically I think the EFI framebuffer does start, as its started at a higher resolution all of a sudden:
https://photos.app.goo.gl/7VMGLhzNXh9rPWVz5/

The strange resolution is because it uses half of a 49-inch screen

Kernel .config
http://dpaste.com/8TWGWME2Z

/var/log/messages
http://0x0.st/XDyR.2

/var/log/syslog
http://0x0.st/XDtr.2

[pietinger]

If you enable this:

[vrghost]

Thank you Pietinger

There is a chance that I, by mistake turned off TTY, it makes an awful lot of sense now that I see it. It is what we would all call a pretty silly idea

Thank you so very very much, both for the help and the great resources, going through your kernel wikis now, great stuff

[pietinger]