bootsplash problem [solved]

[polle]

I installed bootsplash on my gentoo with gentoo-2.6.1 kernel. First I searched the forum and with that help the install went well.
I'm able to boot with the splashscreen. It works in verbose and silent mode.
But when I shut down or switch to a console I get flashing coloured blocks all over the screen. The PC shuts down after while but the consoles 1-6 stay unusable, although I can switch back to X in console 7 without problems.
I tried this two grub.conf with same result:
title=Gentoo 1.4 kernel_2.6.1 12januari2004
root(hd1,5)
kernel /bzImage_2.6.1 root=/dev/hdb7 hdd=ide-cd hdc=ide-cd video=mtrr,vesa:1024x768 vga=0x317 splash=verbose
initrd=/initrd-1024x768

title=Gentoo 1.4 kernel_2.6.1 12januari2004
root(hd1,5)
kernel /bzImage_2.6.1 root=/dev/hdb7 hdd=ide-cd hdc=ide-cd video=vesa:ywrap,mtrr vga=0x317 splash=verbose
initrd=/initrd-1024x768

and this is some more output
eddy $ cat /proc/splash
Splash screen v3.1.3-2003/11/14 (0x07, 1024x768): on

eddy # fbset -i

mode "1024x768-76"
# D: 78.653 MHz, H: 59.949 kHz, V: 75.694 Hz
geometry 1024 768 1024 768 16
timings 12714 128 32 16 4 128 4
rgba 5/11,6/5,5/0,0/0
endmode

Frame buffer device information:
Name : VESA VGA
Address : 0xe2000000
Size : 4194304
Type : PACKED PIXELS
Visual : TRUECOLOR
XPanStep : 0
YPanStep : 0
YWrapStep : 0
LineLength : 2048
Accelerator : No

eddy # dmesg | grep RAM
BIOS-provided physical RAM map:
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
RAMDISK: Couldn't find valid RAM disk image starting at 0.

I also found on the forum that this could be caused by a plugged in tv-out cable, so I disconnected this and stopped nvtv but still no luck

anyone an idea?

[polle]

It's ok now, seems disconnecting the tvout cable and stopping nvtv was not enough, removed nvtv from default level, disconnected and rebooted, problem solved

[Sir Al]