cant connect USB palm Tungsten E

[thecooptoo]

upgraded to 2.6.2 kernel USB stuff compiled in the kernel
USB printer works

pressing the hotsync for the Tungsten E:

anyone managed to get the 2 to communicate together?

bash-2.05b$ dmesg |grep usb
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 17:42:26 Oct 19 2003
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
usb-uhci.c: USB UHCI at I/O 0xe400, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb.c: registered new driver usblp
printer.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x04E8 pid 0x300C
usb.c: registered new driver serial
usbserial.c: USB Serial Driver core v1.4
usbserial.c: USB Serial support registered for Handspring Visor / Palm 4.0 / Clié 4.x
usbserial.c: USB Serial support registered for Sony Clié 3.5
printer.c: usblp0: out of paper
printer.c: usblp0: ok
printer.c: usblp0: out of paper
usb.c: USB device 3 (vend/prod 0x830/0x60) is not claimed by any active driver.
bash-2.05b$