| View previous topic :: View next topic |
| Author |
Message |
Azariah
n00b
Joined: 05 Apr 2004
Posts: 8
|
 Posted: Wed Apr 14, 2004 7:30 pm Post subject: Finding modules in make menuconfig |
 |
|
When I boot to the LiveCD Gentoo autodetects all of my hardware correctly.
I can run an lsmod and see which modules have been loaded.
Is there an easy way to take the output of the lsmod command and find each of those modules in make menuconfig? Some of them are obvious, but some of them might take a bit of digging if I have to go figure out where that particular module is located. |
|
| Back to top |
|
 |
GentooBox
Veteran
Joined: 22 Jun 2003
Posts: 1168
Location: Denmark
|
| Posted: Wed Apr 14, 2004 7:50 pm Post subject: |
|
|
well, what kind of hardware do you have ? maby we can help you.
_________________
Encrypt, lock up everything and duct tape the rest |
|
| Back to top |
|
|
Azariah
n00b
Joined: 05 Apr 2004
Posts: 8
|
| Posted: Wed Apr 14, 2004 8:03 pm Post subject: |
|
|
Via CL10000 mini-ITX. Everything is on-board, so that's the only thing ith drivers.
I don't mind digging through make menuconfig for all of it. I just thought that would be a lot of wasted effort if there were an easier way. |
|
| Back to top |
|
|
|
Installing Gentoo
