tecknojunky
Veteran
Joined: 19 Oct 2002
Posts: 1937
Location: Montréal
|
 Posted: Thu May 20, 2004 2:34 am Post subject: Check out my dmesg |
 |
|
I've been using the same .config file since 2.6.0-test9 (or about) and I noticed things like options that refused to open in menuconfig and stuff. So I made one from scratch, and switch from mm-source to vanilla. But dmesg contains lots of warnings. Care explaining?
| Code: | Linux version 2.6.6-rc1 (root@manitou) (version gcc 3.3.2 20031218 (Gentoo Linux 3.3.2-r5, propolice-3.3-7)) #2 Wed May 19 21:37:21 EDT 2004
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000013ff0000 (usable)
BIOS-e820: 0000000013ff0000 - 0000000013ff8000 (ACPI data)
BIOS-e820: 0000000013ff8000 - 0000000014000000 (ACPI NVS)
BIOS-e820: 00000000ffef0000 - 00000000fff00000 (reserved)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
319MB LOWMEM available.
On node 0 totalpages: 81904
DMA zone: 4096 pages, LIFO batch:1
Normal zone: 77808 pages, LIFO batch:16
HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
ACPI disabled because your bios is from 97 and too old
You can enable it with acpi=force
Built 1 zonelists
Kernel command line: root=/dev/hda3 idebus=66 pci=biosirq video=sisfb:mode:1280x1024x16,mem:12288,rate:75 elevator=cfq gentoo=nodevfs splash=silent
ide_setup: idebus=66
sisfb: Options mode:1280x1024x16,mem:12288,rate:75
bootsplash: silent mode.
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
PID hash table entries: 2048 (order 11: 16384 bytes)
Detected 601.471 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Memory: 320104k/327616k available (2584k kernel code, 6772k reserved, 985k data, 172k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 1187.84 BogoMIPS
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
checking if image is initramfs...it isn't (ungzip failed); looks like an initrd
Freeing initrd memory: 157k freed
CPU: After generic identify, caps: 0383fbff 00000000 00000000 00000000
CPU: After vendor identify, caps: 0383fbff 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After all inits, caps: 0383fbff 00000000 00000000 00000040
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel Celeron (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 601.0298 MHz.
..... host bus clock speed is 66.0810 MHz.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfd9f8, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: Found PnP BIOS installation structure at 0xc00f7000
PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0x5dd4, dseg 0xf0000
PnPBIOS: 11 nodes reported by PnP BIOS; 11 recorded by driver
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ACPI: ACPI tables contain no PCI IRQ routing entries
PCI: Invalid ACPI-PCI IRQ routing table
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Uncovering SIS18 that hid as a SIS503 (compatible=0)
Enabling SiS 96x SMBus.
PCI: Using IRQ router SIS [1039/0018] at 0000:00:01.0
sisfb: Video ROM found and mapped to c00c0000
sisfb: Framebuffer at 0xe0000000, mapped to 0xd4804000, size 65536k
sisfb: MMIO at 0xefee0000, mapped to 0xd8805000, size 128k
sisfb: Memory heap starting at 12288K
sisfb: CRT1 DDC probing failed
sisfb: Default mode is 1280x1024x16 (75Hz)
sisfb: Initial vbflags 0x0
sisfb: Added MTRRs
sisfb: Installed SISFB_GET_INFO ioctl (80046ef8)
sisfb: Installed SISFB_GET_VBRSTATUS ioctl (80046ef9)
sisfb: 2D acceleration is enabled, scrolling mode ypan (auto-max)
fb0: SIS 630/730 VGA frame buffer device, Version 1.6.25
sisfb: (C) 2001-2004 Thomas Winischhofer.
Machine check exception polling timer started.
ikconfig 0.7 with /proc/config*
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
udf: registering filesystem
Initializing Cryptographic API
bootsplash 3.1.4-2004/02/19: looking for picture.... silentjpeg size 75071 bytes, found, but framebuffer can't handle it!
Console: switching to colour frame buffer device 160x64
Real Time Clock Driver v1.12
Non-volatile memory driver v1.2
Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
Using cfq io scheduler
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 66MHz system bus speed for PIO modes
SIS5513: IDE controller at PCI slot 0000:00:00.1
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SIS5513: SiS630 ATA 66 controller
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 91080D5, ATA DISK drive
hdb: ST38641A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdc: HITACHI DVD-ROM GD-5000, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 128KiB
hda: 21095424 sectors (10800 MB) w/512KiB Cache, CHS=20928/16/63, UDMA(33)
hda: hda1 hda2 hda3
hdb: max request size: 128KiB
hdb: 16514064 sectors (8455 MB) w/128KiB Cache, CHS=16383/16/63, UDMA(33)
hdb: hdb1 hdb2 hdb3
hdc: ATAPI 40X DVD-ROM drive, 512kB Cache, DMA
Uniform CD-ROM driver Revision: 3.20
libata version 1.02 loaded.
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
serio: i8042 AUX port at 0x60,0x64 irq 12
input: ImPS/2 Logitech Wheel Mouse on isa0060/serio1
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
Advanced Linux Sound Architecture Driver Version 1.0.4rc2 (Tue Mar 30 08:19:30 2004 UTC).
ALSA device list:
No soundcards found.
oprofile: using NMI interrupt.
NET: Registered protocol family 2
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Couldn't find valid RAM disk image starting at 0.
found reiserfs format "3.6" with standard journal
reiserfs: using ordered data mode
Reiserfs journal params: device hda3, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
reiserfs: checking transaction log (hda3) for (hda3)
Using r5 hash to sort names
VFS: Mounted root (reiserfs filesystem) readonly.
Freeing unused kernel memory: 172k freed
Adding 1052248k swap on /dev/hda2. Priority:-1 extents:1
[drm] Initialized sis 1.1.0 20030826 on minor 0
sis900.c: v1.08.07 11/02/2003
PCI: Found IRQ 11 for device 0000:00:01.1
PCI: Sharing IRQ 11 with 0000:00:0f.1
eth0: SiS 900 Internal MII PHY transceiver found at address 1.
eth0: Using transceiver found at address 1 as default
eth0: SiS 900 PCI Fast Ethernet at 0xde00, IRQ 11, 00:d0:09:ac:20:f9.
PCI: Found IRQ 9 for device 0000:00:0f.0
Linux agpgart interface v0.100 (c) Dave Jones
agpgart: Detected SiS 630 chipset
agpgart: Maximum main memory to use for agp memory: 262M
agpgart: AGP aperture is 64M @ 0xf4000000
eth0: Media Link On 100mbps full-duplex
blk: queue c1330a00, I/O limit 4095Mb (mask 0xffffffff)
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
blk: queue c1330600, I/O limit 4095Mb (mask 0xffffffff)
hdb: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: task_no_data_intr: error=0x04 { DriveStatusError }
hdc: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
hdc: drive_cmd: error=0x04Aborted Command
nfs warning: mount version older than kernel
nfs warning: mount version older than kernel
NET: Registered protocol family 10
Disabled Privacy Extensions on device c04361c0(lo)
IPv6 over IPv4 tunneling driver
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
bootsplash 3.1.4-2004/02/19: looking for picture.... found, but framebuffer can't handle it!
eth0: no IPv6 routers present
Console: switching to colour frame buffer device 160x64
sisfb: Unsupported rate 49 for 720x576
sisfb: Unsupported rate 75 for 768x576
sisfb: Unsupported rate 92 for 640x400
sisfb: Unsupported rate 99 for 400x300
sisfb: Unsupported rate 84 for 320x240
sisfb: Unsupported rate 85 for 320x200
Console: switching to colour frame buffer device 160x64
|
_________________
(7 of 9) Installing star-trek/species-8.4.7.2::talax. |
|
Kernel & Hardware
