Gentoo Forums
Gentoo Forums
Gentoo Forums
Quick Search: in
Meinungen zu smartctrl-Ausgabe
View unanswered posts
View posts from last 24 hours
View posts from last 7 days

 
Reply to topic    Gentoo Forums Forum Index Deutsches Forum (German)
View previous topic :: View next topic  
Author Message
Torstello
n00b
n00b


Joined: 11 Feb 2003
Posts: 35

PostPosted: Wed Oct 27, 2004 8:05 pm    Post subject: Meinungen zu smartctrl-Ausgabe Reply with quote

Hi @ all

da ich in /var/log/messages einige smartctrl-meldungen gesehen habe, habe ich mal
smartctrl -a /dev/hda auf meinem Fileserver gemacht.

kann mir jemand was zu den Fehlern sagen?
es sind welche aufgelistet aber in der Zusammenfassung unten nicht.

Quote:

smartctl version 5.26 Copyright (C) 2002-3 Bruce Allen
Home page is http://smartmontools.sourceforge.net/

=== START OF INFORMATION SECTION ===
Device Model: Maxtor 6Y120L0
Serial Number: Y40XKVPE
Firmware Version: YAR41BW0
Device is: In smartctl database [for details use: -P show]
ATA Version is: 7
ATA Standard is: ATA/ATAPI-7 T13 1532D revision 0
Local Time is: Wed Oct 27 21:40:37 2004 Local time zone must be set--see zic m
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status: (0x82) Offline data collection activity was
completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 182) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 61) minutes.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
3 Spin_Up_Time 0x0027 194 194 063 Pre-fail Always - 14702
4 Start_Stop_Count 0x0032 253 253 000 Old_age Always - 1160
5 Reallocated_Sector_Ct 0x0033 253 253 063 Pre-fail Always - 0
6 Read_Channel_Margin 0x0001 253 253 100 Pre-fail Offline - 0
7 Seek_Error_Rate 0x000a 253 252 000 Old_age Always - 0
8 Seek_Time_Performance 0x0027 247 246 187 Pre-fail Always - 43332
9 Power_On_Minutes 0x0032 240 240 000 Old_age Always - 403h+06m
10 Spin_Retry_Count 0x002b 253 252 157 Pre-fail Always - 0
11 Calibration_Retry_Count 0x002b 253 252 223 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 252 252 000 Old_age Always - 647
192 Power-Off_Retract_Count 0x0032 253 253 000 Old_age Always - 0
193 Load_Cycle_Count 0x0032 253 253 000 Old_age Always - 0
194 Temperature_Celsius 0x0032 253 253 000 Old_age Always - 38
195 Hardware_ECC_Recovered 0x000a 253 252 000 Old_age Always - 7347
196 Reallocated_Event_Count 0x0008 253 253 000 Old_age Offline - 0
197 Current_Pending_Sector 0x0008 253 253 000 Old_age Offline - 0
198 Offline_Uncorrectable 0x0008 253 253 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0008 197 182 000 Old_age Offline - 17
200 Multi_Zone_Error_Rate 0x000a 253 252 000 Old_age Always - 0
201 Soft_Read_Error_Rate 0x000a 234 226 000 Old_age Always - 17523
202 TA_Increase_Count 0x000a 247 235 000 Old_age Always - 11
203 Run_Out_Cancel 0x000b 253 252 180 Pre-fail Always - 112
204 Shock_Count_Write_Opern 0x000a 253 252 000 Old_age Always - 0
205 Shock_Rate_Write_Opern 0x000a 253 252 000 Old_age Always - 0
207 Spin_High_Current 0x002a 253 252 000 Old_age Always - 0
208 Spin_Buzz 0x002a 253 252 000 Old_age Always - 0
209 Offline_Seek_Performnce 0x0024 198 192 000 Old_age Offline - 0
99 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
100 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
101 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0

SMART Error Log Version: 1
Warning: ATA error count 17 inconsistent with error log pointer 5

ATA Error Count: 17 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Timestamp = decimal seconds since the previous disk power-on.
Note: timestamp "wraps" after 2^32 msec = 49.710 days.

Error 17 occurred at disk power-on lifetime: 493 hours
When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 80 01 00 f0 Error: ICRC, ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 80 80 01 00 f0 08 413509.008 READ DMA
c8 00 80 80 01 00 f0 08 413508.960 READ DMA
10 00 3f 00 00 00 f0 08 413508.944 RECALIBRATE [OBS-4]
c8 00 80 80 01 00 f0 08 413508.896 READ DMA
c8 00 80 80 01 00 f0 08 413508.848 READ DMA

Error 16 occurred at disk power-on lifetime: 493 hours
When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 80 01 00 f0 Error: ICRC, ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 80 80 01 00 f0 08 413508.960 READ DMA
10 00 3f 00 00 00 f0 08 413508.944 RECALIBRATE [OBS-4]
c8 00 80 80 01 00 f0 08 413508.896 READ DMA
c8 00 80 80 01 00 f0 08 413508.848 READ DMA
c8 00 80 00 01 00 f0 08 413508.848 READ DMA

Error 15 occurred at disk power-on lifetime: 493 hours
When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 80 01 00 f0 Error: ICRC, ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 80 80 01 00 f0 08 413508.896 READ DMA
c8 00 80 80 01 00 f0 08 413508.848 READ DMA
c8 00 80 00 01 00 f0 08 413508.848 READ DMA
c8 00 80 80 00 00 f0 08 413508.848 READ DMA
c8 00 80 00 00 00 f0 08 413508.848 READ DMA

Error 14 occurred at disk power-on lifetime: 493 hours
When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 80 01 00 f0 Error: ICRC, ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 80 80 01 00 f0 08 413508.848 READ DMA
c8 00 80 00 01 00 f0 08 413508.848 READ DMA
c8 00 80 80 00 00 f0 08 413508.848 READ DMA
c8 00 80 00 00 00 f0 08 413508.848 READ DMA
ca 00 01 7b 2a c1 f0 08 413506.544 WRITE DMA

Error 13 occurred at disk power-on lifetime: 493 hours
When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 01 7b 2a c1 f0 Error: ICRC, ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
ca 00 01 7b 2a c1 f0 08 413506.480 WRITE DMA
ca 00 01 7b 2a c1 f0 08 413506.352 WRITE DMA
ca 00 01 9a ca bf f1 08 413506.352 WRITE DMA
ca 00 01 8e 60 b0 f1 08 413506.352 WRITE DMA
ca 00 01 b3 da da f0 08 413506.352 WRITE DMA

SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 4027 -



Gruß,

Torstello
Back to top
View user's profile Send private message
Romses
Apprentice
Apprentice


Joined: 20 Jan 2004
Posts: 257
Location: Frankfurt

PostPosted: Wed Oct 27, 2004 8:18 pm    Post subject: Re: Meinungen zu smartctrl-Ausgabe Reply with quote

Torstello wrote:

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED


Ich würde sagen, dass mit deiner Festplatte soweit alles OK ist.

Alles andere sind detaillierte Daten, die deine Festplatte ausspuckt, wenn ihr smart-status abgerufen wird...

evtl. gibt es auf der Website von smarttools einen hint dazu...

Gruß Romses
Back to top
View user's profile Send private message
Display posts from previous:   
Reply to topic    Gentoo Forums Forum Index Deutsches Forum (German) All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum