| View previous topic :: View next topic |
| Author |
Message |
dmclaug881
n00b
Joined: 10 Jan 2005
Posts: 6
Location: chicago
|
 Posted: Mon Jan 10, 2005 4:48 am Post subject: hppa risc c110 scsi hard drive |
 |
|
I am installing gentoo on my hp pa-risc 9000 c110 with a 120mhz 3f2 bit proccessor 512 ram and a 3gig fwscsi a cdrom scsi . when i boot to the cdrom gentoo starts out fine but when i go to partition it says my sda is not listed in fstab when i look at fstab i do not see my scsi hard drive am i suppose to add to fstab or is it renamed from sda to ?
thanks
dan |
|
| Back to top |
|
 |
gmsoft
Retired Dev
Joined: 08 Jun 2004
Posts: 20
|
| Posted: Mon Jan 10, 2005 10:49 am Post subject: |
|
|
| Maybe you'll have more luck with the 2004.2 livecd. The 2004.3 livecd was the first 2.6 livecd and I had some troube creating a working kernel config for all platforms. |
|
| Back to top |
|
|
dmclaug881
n00b
Joined: 10 Jan 2005
Posts: 6
Location: chicago
|
| Posted: Thu Jan 13, 2005 7:54 pm Post subject: tried version 2 |
|
|
tried version 2 in recognizes the haddrive and was able to install but when i did a check for tulip it said no such device but in version 3 it was able to recognize my nic card  |
|
| Back to top |
|
|
gmsoft
Retired Dev
Joined: 08 Jun 2004
Posts: 20
|
| Posted: Thu Jan 13, 2005 7:58 pm Post subject: |
|
|
| modprobe tulip on 2004.2 should work. |
|
| Back to top |
|
|
dmclaug881
n00b
Joined: 10 Jan 2005
Posts: 6
Location: chicago
|
| Posted: Fri Jan 14, 2005 1:19 am Post subject: tulip |
|
|
| It states the kernel is unable to locate device wrong device |
|
| Back to top |
|
|
joejgarcia
n00b
Joined: 25 Jan 2005
Posts: 1
|
| Posted: Tue Jan 25, 2005 10:08 pm Post subject: type ifconfig |
|
|
| I was searching the forums for as I too could not see the fwscsi with 2004.3 and ran across this thread. 2004.2 does see the fwscsi and if you type ifconfig you should see that eth0 is already present. The Tulip driver is built into the kernel. Just type net-setup eth0 and you should be good to go. |
|
| Back to top |
|
|
RanDom_ErrOr
n00b
Joined: 03 Mar 2005
Posts: 5
|
| Posted: Fri Mar 04, 2005 2:11 am Post subject: |
|
|
tulip is NOT used its the older lasi standard. you have to configure the card to use DHCP.
works fine for me and i have the same setup, well almost...
_________________
I own 3 HP 9000/C110 boxes, One is working, and 2 are spare parts.
Gentoo Linux is installed on the working one. |
|
| Back to top |
|
|
|
Gentoo on Alternative Architectures
