| View previous topic :: View next topic |
| Author |
Message |
pactoo
Guru
Joined: 18 Jul 2004
Posts: 553
|
 Posted: Wed Mar 16, 2005 1:14 pm Post subject: Can't use SATA drives on KT880 mobo (solved) |
 |
|
Hi,
I do have a strange problem with my onboard sata controller on a via kt880 board. I can modprobe the module fine, as long as no drive is connected. As soon as I boot with a drive connected, the kernel will hang if I try to load the modules through /etc/modules.autoload.d, if I load the sata_via module after booting, I get an emergency warning (see below):
Ive tested this with three drives, all of which are brand new, so a harddisk issue is very unlikely. I have no idea, why there is a reference to the soundcard when probing this modules (see syslog).
Using stock development-sources-2.6.10-r2. Thy evil module does get loaded besides all the warnings and I can access the drive, however, doing a mke2fs goes fine until inode/block 103 of ~1800 and after that starts to crawl. After ~12hours I decided to reset the machine, as the formating was still not finished.
| Code: |
root # modprobe sata_via
Message from syslogd@gewitterhexe at Tue Mar 15 08:16:53 2005 ... gewitterhexe kernel: Disabling IRQ #11
root #
|
related Excerpts from various logfiles follow:
syslog:
Mar 15 08:16:53 gewitterhexe kernel: irq 11: nobody cared!
Mar 15 08:16:53 gewitterhexe kernel: [<c013117a>] __report_bad_irq+0x2a/0x90
Mar 15 08:16:53 gewitterhexe kernel: [<c0130a79>] handle_IRQ_event+0x39/0x70
Mar 15 08:16:53 gewitterhexe kernel: [<c01312a3>] note_interrupt+0xa3/0xd0
Mar 15 08:16:53 gewitterhexe kernel: [<c0130c10>] __do_IRQ+0x160/0x180
Mar 15 08:16:53 gewitterhexe kernel: [<c0104c2c>] do_IRQ+0x5c/0x60
Mar 15 08:16:53 gewitterhexe kernel: [<c01030ee>] common_interrupt+0x1a/0x20
Mar 15 08:16:53 gewitterhexe kernel: [<c0130a69>] handle_IRQ_event+0x29/0x70
Mar 15 08:16:53 gewitterhexe kernel: [<c0130b95>] __do_IRQ+0xe5/0x180
Mar 15 08:16:53 gewitterhexe kernel: [<c0104c0e>] do_IRQ+0x3e/0x60
Mar 15 08:16:53 gewitterhexe kernel: =======================
Mar 15 08:16:53 gewitterhexe kernel: [<c01030ee>] common_interrupt+0x1a/0x20
Mar 15 08:16:53 gewitterhexe kernel: [<c011b680>] __do_softirq+0x30/0x90
Mar 15 08:16:53 gewitterhexe kernel: [<c0104d11>] do_softirq+0x41/0x50
Mar 15 08:16:53 gewitterhexe kernel: =======================
Mar 15 08:16:53 gewitterhexe kernel: [<c0130a35>] irq_exit+0x35/0x40
Mar 15 08:16:53 gewitterhexe kernel: [<c0104c15>] do_IRQ+0x45/0x60
Mar 15 08:16:53 gewitterhexe kernel: [<c01030ee>] common_interrupt+0x1a/0x20
Mar 15 08:16:53 gewitterhexe kernel: [<c01005c0>] default_idle+0x0/0x30
Mar 15 08:16:53 gewitterhexe kernel: [<c01005e3>] default_idle+0x23/0x30
Mar 15 08:16:53 gewitterhexe kernel: [<c010065f>] cpu_idle+0x2f/0x60
Mar 15 08:16:53 gewitterhexe kernel: [<c03dd81f>] start_kernel+0x14f/0x170
Mar 15 08:16:53 gewitterhexe kernel: [<c03dd3a0>] unknown_bootoption+0x0/0x1f0
Mar 15 08:16:53 gewitterhexe kernel: handlers:
Mar 15 08:16:53 gewitterhexe kernel: [<c02af610>] (usb_hcd_irq+0x0/0x90)
Mar 15 08:16:53 gewitterhexe kernel: [<e0d80530>] (snd_via82xx_interrupt+0x0/0x140 [snd_via82xx])
Mar 15 08:16:53 gewitterhexe kernel: Disabling IRQ #11
messages:
Mar 15 08:16:52 gewitterhexe kernel: ACPI: PCI interrupt 0000:00:0f.0 -> GSI 10 (level, low) -> IRQ 10
Mar 15 08:16:52 gewitterhexe kernel: sata_via(0000:00:0f.0): routed to hard irq line 11
Mar 15 08:16:52 gewitterhexe kernel: ata1: SATA max UDMA/133 cmd 0xE100 ctl 0xE202 bmdma 0xE500 irq 10
Mar 15 08:16:52 gewitterhexe kernel: ata2: SATA max UDMA/133 cmd 0xE300 ctl 0xE402 bmdma 0xE508 irq 10
Mar 15 08:16:52 gewitterhexe kernel: ata1: dev 0 ATA, max UDMA/133, 488397168 sectors: lba48
Mar 15 08:16:53 gewitterhexe kernel: ata1: dev 0 configured for UDMA/133
Mar 15 08:16:53 gewitterhexe kernel: scsi0 : sata_via
Mar 15 08:16:53 gewitterhexe kernel: ata2: no device found (phy stat 00000000)
Mar 15 08:16:53 gewitterhexe kernel: scsi1 : sata_via
Mar 15 08:16:53 gewitterhexe kernel: Vendor: ATA Model: ST3250823AS Rev: 3.01
Mar 15 08:16:53 gewitterhexe kernel: Type: Direct-Access ANSI SCSI revision: 05
Mar 15 08:16:53 gewitterhexe scsi.agent[7706]: disk at /devices/pci0000:00/0000:00:0f.0/host0/target0:0:0/0:0:0:0
Mar 15 08:16:53 gewitterhexe kernel: SCSI device sda: 488397168 512-byte hdwr sectors (250059 MB)
Mar 15 08:16:53 gewitterhexe kernel: SCSI device sda: drive cache: write back
Mar 15 08:16:53 gewitterhexe kernel: SCSI device sda: 488397168 12-byte hdwr sectors (250059 MB)
Mar 15 08:16:53 gewitterhexe kernel: SCSI device sda: drive cache: write back
Mar 15 08:16:55 gewitterhexe kernel: sda: sda1
Mar 15 08:16:55 gewitterhexe kernel: Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
debug:
Mar 15 08:16:52 gewitterhexe kernel: libata version 1.10 loaded.
Mar 15 08:16:52 gewitterhexe kernel: sata_via version 1.0
Mar 15 08:16:52 gewitterhexe kernel: ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4023 85:3469 86:3c01 87:4023 88:407f |
|
| Back to top |
|
 |
pactoo
Guru
Joined: 18 Jul 2004
Posts: 553
|
| Posted: Wed Mar 16, 2005 8:18 pm Post subject: |
|
|
| Kernel 2.6.11.2 does the magic, as it also fixes the via-agp/radeon-drm incompatibility. So I highly recommend this kernel for KT-880 users |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Kernel & Hardware
