View previous topic :: View next topic |
Author |
Message |
cgkanchi n00b
Joined: 15 Apr 2005 Posts: 6
|
Posted: Fri Apr 15, 2005 8:21 pm Post subject: ALi Chipset Network Problem |
|
|
I am a fairly experienced x86 linux user and I recently upgraded to an x86-64. I decided to try gentoo since my disribution of choice (Slackware) doesn't have an x86-64 version out yet. I booted off the universal install cd for x86-64 and checked my network configuration. ifconfig shows eth0 fine. I have a static IP, so I configured the following using net-setup:
IP: 10.0.0.245
Broadcast: 10.0.1.255 ---> Also tried 10.0.0.255
Netmask: 255.0.0.0
Gateway: 10.0.2.1
DNS: 90.0.2.1
I have an Asrock Combo-Z motherboard which has a ULi LAN chip. ifconfig again shows the interface as up and with the appropriate IP address, netmask, broadcast address, etc. route also shows correct information. However, I can't access the internet. I can't even ping the gateway. I can however ping both localhost (duh!) and the broadcast address (either one) fine. Just in case net-setup was missing something, I even used ifconfig and route to manually configure the network (even though I was sure that net-setup was fine). Please help!
Thanks in advance,
cgkanchi |
|
Back to top |
|
|
Shrekkie n00b
Joined: 22 May 2003 Posts: 64 Location: Belgium
|
Posted: Sat Apr 16, 2005 1:34 pm Post subject: |
|
|
Hey cgkanchi,
Edit /etc/conf.d/net
Code: |
# /etc/conf.d/net:
# $Header: /home/cvsroot/gentoo-src/rc-scripts/etc/conf.d/net,v 1.7 2002/11/18 19:39:22 azarah Exp $
# Global config file for net.* rc-scripts
# This is basically the ifconfig argument without the ifconfig $iface
#
iface_eth0="10.0.0.245 broadcast 10.255.255.255 netmask 255.0.0.0"
gateway="eth0/10.0.2.1"
|
edit /etc resolv.conf for the DNS
Code: |
nameserver 90.0.2.1
|
I believe your broadcast should be 10.255.255.255 since your net is 10.0.0.0/8 and broadcast is always the last ip.
Now restart the interface with /etc/init.d/net.eth0 start and add it to default runlevel to start auto next time you boot.
This is achieved with rc-update add net.eth0 default.
Then check your ipsettings with ifconfig and check connectivity.
Thank you for choosing gentoo.
_________________ irc.michiels.nu #lobby if you wanna talk to me. |
|
Back to top |
|
|
cgkanchi n00b
Joined: 15 Apr 2005 Posts: 6
|
Posted: Sun Apr 17, 2005 5:39 am Post subject: |
|
|
OK, this didn't work either. However, I've seen that a lot of people are having problems with this chipset and it seems to clear up once gentoo is installed. However, since I can't download the kernel, I have to use the one in distfiles. Could someone guide me through using emerge in a networkless environment?
Cheers,
cgkanchi |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|