Jijua
n00b
Joined: 26 Dec 2004
Posts: 30
Location: Milan, Italy
|
 Posted: Tue May 03, 2005 7:20 pm Post subject: Logitech ClickSmart 820 - Camera not functioning |
 |
|
Hi all!
I've got a Logitech ClickSmart 820 camera and I cannot manage to make it work.
As a usb mass storage the camera has no problem, while if I try to have its CCD online then the problems come out.
I know that the chipset is supported by the spca5xx driver, so I installed it and now I have the relative device in /dev/v4l/video1 (video0 is my tv card) linked to /dev/video1.
Here is the message from dmesg:
| Code: | jijua@linux jijua $ dmesg
ohci_hcd 0000:00:02.1: wakeup
usb 3-1: new full speed USB device using address 2
/var/tmp/portage/spca5xx-20050328/work/spca5xx-20050328/drivers/usb/spca5xx.c: USB SPCA5XX camera found. Logitech ClickSmart 820 (SPCA533+unknown CCD)
/var/tmp/portage/spca5xx-20050328/work/spca5xx-20050328/drivers/usb/spca5xx.c: [spca5xx_probe:7806] Camera type JPEG
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Model: Camera storage Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 14784 512-byte hdwr sectors (8 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
/dev/scsi/host0/bus0/target0/lun0: p1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
USB Mass Storage device found at 2jijua@linux jijua $ gqcam -v /dev/video0
Killed
usbcore: registered new driver spca50x
/var/tmp/portage/spca5xx-20041224/work/spca5xx-20041224/drivers/usb/spca50x.c: spca5xx driver 0.55 registered
|
Now, I have loaded the spca5xx module to the default runlevel for boot time, but when I try to access the device with Gqcam I get a permission denied message:
| Code: | jijua@linux jijua $ gqcam -v /dev/video1
/dev/video: Permission denied |
Note that my user is in the video group.
Some of you have ideas to solve this and make my camera work?
Thanks in advance for the patience  |
|
Multimedia
