| View previous topic :: View next topic |
| Author |
Message |
trossachs
Veteran
Joined: 22 Jan 2004
Posts: 1204
Location: London
|
 Posted: Fri Jul 29, 2005 12:47 am Post subject: [CLOSED] dcc UDP error |
 |
|
Not much about for this one. An awful long time searching various forums. It's 02h00 now and time for bed. But just before I go I thought I would just if anybody ever managed to solve this error in the mailllog:
| Code: | | socket(UDP): Address family not supported by protocol |
Now the current version is: 1.3.10 but this is not supported by Portage even when added to keyworks or unmasked, (if it was masked... ) The version listed with emerge is 1.2.74. Has anybody ever managed to get this to work properly or is there any alternative? I using Pyzor, Razor and SA, but somethig else would help.
There was even some post about enabling various ports on my firewall to allow thru udp so that dcc could update traffic which I have done, but to no avail.
Last edited by trossachs on Wed Aug 24, 2005 10:58 am; edited 1 time in total |
|
| Back to top |
|
 |
toxicnaan
n00b
Joined: 13 Nov 2004
Posts: 68
|
| Posted: Fri Jul 29, 2005 12:53 am Post subject: |
|
|
is this something to do with ipv6 perhaps?
are you running ipv6 and ipv4? your application might be trying to use an ipv4? or ipv6 address, but not support in the kernel has been enable?
just a guess! |
|
| Back to top |
|
|
trossachs
Veteran
Joined: 22 Jan 2004
Posts: 1204
Location: London
|
| Posted: Fri Jul 29, 2005 1:09 am Post subject: |
|
|
| Funny you should mention but I was looking at this in /etc/rc.conf. IP6 was enabled, but I corrected it. What should I restart to reflect this change? |
|
| Back to top |
|
|
toxicnaan
n00b
Joined: 13 Nov 2004
Posts: 68
|
| Posted: Fri Jul 29, 2005 10:12 am Post subject: |
|
|
restart your network
/etc/init.d/network restart
or
/etc/init.d/net.eth0 restart
have look around!!!!!!!
good luck |
|
| Back to top |
|
|
|
Networking & Security
