| View previous topic :: View next topic |
| Author |
Message |
Poe
Bodhisattva
Joined: 03 Apr 2004
Posts: 2155
Location: Mysłowice/Lublin, Poland
|
 Posted: Fri Nov 18, 2005 6:20 pm Post subject: [HARDWARE/DMA]Wyłączenie DMA |
 |
|
Mam dwa dyski.. moj WD40gb jako PMaster i Segate 120gb ATA (znajomego) jako PSlave (oba bez zworek, bo nie mam, ale na odpowiedniej tasmie, dobrze podpiete, zawsze dzialalo). I problem jest taki, ze nagle, pewnego pieknego dnia, jak odpalalem gentoo zaczelo mi wypluwac jakies bledy zwiazane z tym dyskiem segate (hdb)
| Code: |
PCI: Via IRQ fixup for 0000:00:11.1, from 255 to 11
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci0000:00:11.1
ide0: BM-DMA at 0xdc00-0xdc07, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xdc08-0xdc0f, BIOS settings: hdc:DMA, hdd:DMA
Probing IDE interface ide0...
input: AT Translated Set 2 keyboard on isa0060/serio0
input: ImPS/2 Generic Wheel Mouse on isa0060/serio1
hda: WDC WD400AB-00CBA1, ATA DISK drive
hdb: ST3120022A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
hdc: SAMSUNG DVD-ROM SD-616T, ATAPI CD/DVD-ROM drive
hdd: LITE-ON LTR-48246S, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 128KiB
hda: 78165360 sectors (40020 MB) w/2048KiB Cache, CHS=65535/16/63, UDMA(100)
hda: cache flushes not supported
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 >
hdb: max request size: 1024KiB
hdb: 234441648 sectors (120034 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
hdb: cache flushes supported
hdb:hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hda: DMA disabled
ide0: reset: success
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
ide0: reset: success
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
end_request: I/O error, dev hdb, sector 0
Buffer I/O error on device hdb, logical block 0
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
ide0: reset: success
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
ide0: reset: success
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide: failed opcode was: unknown
end_request: I/O error, dev hdb, sector 0
Buffer I/O error on device hdb, logical block 0
unable to read partition table
hdc: ATAPI 48X DVD-ROM drive, 512kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.20
hdd: ATAPI 48X CD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33)
[...potem juz przy starcie, tuz po sprawdzeniu hda wyskakuje mi rameczka, ze dma jest zdiseablowane przez co dysk moze wolniej dzialac.. jakos tak]
|
a, jeszcze zanim wyskoczy mi ta ramka o niedostepnym dma wywala, ze nie moze zamontowac tych partycji z hdb (mam je w fstabie)
| Code: |
[...]
/dev/hdb5 /mnt/badur1 ntfs iocharset=iso8859-2,rw,users,umask=000 0 0
/dev/hdb6 /mnt/badur2 ntfs iocharset=iso8859-2,rw,users,umask=000 0 0
/dev/hdb7 /mnt/badur3 ntfs iocharset=iso8859-2,rw,users,umask=000 0 0
|
zawsze mi dzialalo tak. nie wiem co sie pokrzanilo.... generalnie pod windowsem widzi ten dysk i czyta z niego dane, ale tu sie cos kopnęło.. jak go odepnę, to wszystko dziala normalnie... problem jest ewidentnie z tym dyskiem.. mam nadzieje ze to cos jest nakopane przeze mnie w Gentoo, a nie skrzanilo sie w dysku, bo bde mial przechlapane...
pozdrawiam
_________________
Hardware:HP Pavilion DV6875SE[C2DT5550@1.83GHz_3GB-DDR2_320GB-SATA_GF8400GS]
http://popularcoffee.blogspot.com - Popkulturowa Kawa
RLU#342333 |
|
| Back to top |
|
 |
Raku
Bodhisattva
Joined: 28 Feb 2004
Posts: 2374
Location: Poland
|
| Posted: Sat Nov 19, 2005 11:10 am Post subject: |
|
|
mi tak sypało w logach jak była taśma walnięta
_________________
raku
Powered by Archlinux  |
|
| Back to top |
|
|
Xax
Guru
Joined: 24 Jul 2003
Posts: 417
Location: Poland, Gliwice, Trynek
|
| Posted: Sun Nov 20, 2005 8:58 pm Post subject: |
|
|
A ja mialem takie cudenka jak moj maxtor w pracy wyzional ducha. Juz mam nowy dysk, maxtor jest trup 
[EDIT]
Jezeli nie zmieniales nic w Gentoo, a uscislajac w kernelu i nagle, z dnia na dzien takie kwiatuszki to nie zwalal bym tego na Gentoo a raczj na dysk. Sproboj raczej tylko ten dysk wlozyc i wlaczyc w ustawieniach biosu aby sie wywalal w czasie startu na wszystkich bledach. U mnie przy takich ustawieniach wyzej wymieniony maxtor blokowal start kompa. |
|
| Back to top |
|
|
Polin
Guru
Joined: 09 Oct 2004
Posts: 318
|
| Posted: Sun Nov 20, 2005 10:28 pm Post subject: |
|
|
| Mialem bardzo podobne bledy, jak sie okazalo - dysk powoli zdychal, co potwierdzilo smartmontools. |
|
| Back to top |
|
|
Poe
Bodhisattva
Joined: 03 Apr 2004
Posts: 2155
Location: Mysłowice/Lublin, Poland
|
| Posted: Mon Nov 21, 2005 6:26 pm Post subject: |
|
|
khm... to zescie mnie pocieszyli.. czemu ten dysk akkurat musi padac w moich rekach.... brrr.. oby to byla jednak tasma, jak raku sugeruje... oby..
_________________
Hardware:HP Pavilion DV6875SE[C2DT5550@1.83GHz_3GB-DDR2_320GB-SATA_GF8400GS]
http://popularcoffee.blogspot.com - Popkulturowa Kawa
RLU#342333 |
|
| Back to top |
|
|
Xax
Guru
Joined: 24 Jul 2003
Posts: 417
Location: Poland, Gliwice, Trynek
|
| Posted: Mon Nov 21, 2005 9:56 pm Post subject: |
|
|
| Poe wrote: | | khm... to zescie mnie pocieszyli.. czemu ten dysk akkurat musi padac w moich rekach.... brrr.. oby to byla jednak tasma, jak raku sugeruje... oby.. |
No w sumie taka nasza rola - pomagac, a jak sie nie da pomoc to chociaz pocieszyc (albo opierniczyc z gory na dol za nieumiejetne wyrazanie mysli w formie pisemnej  )
PS To na bank tasma  |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Polskie forum (Polish) 
