View previous topic :: View next topic |
Author |
Message |
infernal211283 Tux's lil' helper
Joined: 23 Jan 2006 Posts: 113 Location: Middle East / Israel
|
Posted: Sat Feb 11, 2006 2:59 pm Post subject: Intel Corporation 82865G Integrated Graphics Controller? |
|
|
Hi,
I'd like to enable hardware accelleration with this graphics card but i'm not sure how to do this, i compiled the i810 driver into the kernel and it seems to work but when i try to play tribes 2 it says that my accelleration is not configured, where should i first look to solve this? _________________ Your ad here. |
|
Back to top |
|
|
rdavl n00b
Joined: 25 Jan 2006 Posts: 52
|
Posted: Sat Feb 11, 2006 4:05 pm Post subject: |
|
|
Could you post your dmesg and lspci perhaps... I have problems with that drivers and chipset on 2.4.22-openmosix kernel and 2.6.14-gentoo-sources...
2.4 is somewath totaly screwed up...
dmesg has enetrys complaining about not finding /dev/agpgart and when i create it X doesn't start without error mesage...
I don't have output of that dmesg in handy right now...
And 2.6 gives a little hope but still no 3D... _________________ "Meow" means "woof" in cat. |
|
Back to top |
|
|
infernal211283 Tux's lil' helper
Joined: 23 Jan 2006 Posts: 113 Location: Middle East / Israel
|
Posted: Sat Feb 11, 2006 4:16 pm Post subject: |
|
|
I think this is the relevant part from dmesg:
vesafb: Intel Corporation, Intel(r)865G Graphics Controller, Hardware Version 0.0 (OEM: Intel(r)865G Graphics Chip Accelerated VGA BIOS)
vesafb: VBE version: 3.0
vesafb: VBIOS/hardware supports DDC2 transfers
vesafb: monitor limits: vf = 160 Hz, hf = 96 kHz, clk = 210 MHz
vesafb: scrolling: redraw
Console: switching to colour frame buffer device 128x48
vesafb: framebuffer at 0xf0000000, mapped to 0xe0080000, using 8000k, total 8000k
fb0: VESA VGA frame buffer device
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected an Intel 865 Chipset.
agpgart: Detected 8060K stolen memory.
agpgart: AGP aperture is 128M @ 0xf0000000
and this is the lspci:
00:02.0 VGA compatible controller: Intel Corporation 82865G Integrated Graphics Controller (rev 02)
Edit: I'm checking if the 3d is enabled by trying the glide screensavers and they all sluggish so i know i'ts not working... is there any software i can manipulate the 3d? _________________ Your ad here. |
|
Back to top |
|
|
|