| View previous topic :: View next topic |
| Author |
Message |
silverblue
n00b
Joined: 20 Oct 2006
Posts: 2
Location: Connecticut, USA
|
 Posted: Fri Oct 20, 2006 5:04 pm Post subject: noob question - current kernel config |
 |
|
Hi All, new to gentoo.
I have installed the stage 3 tarball from the liveCD, but I am unable to get X server working - it chokes on the 'GLcore' module. My first plan of attack will be to set up my NVIDIA graphics card according to the Gentoo Linux nVidia guide.
My question is this - is it possible to look at the current kernel configuration without actually compiling a new one? I would like to compile my own kernel eventually, but I would like to get a basic system up and running first.
Thanks
-sb |
|
| Back to top |
|
 |
NeddySeagoon
Administrator
Joined: 05 Jul 2003
Posts: 54585
Location: 56N 3W
|
| Posted: Fri Oct 20, 2006 5:26 pm Post subject: |
|
|
silverblue,
Welcome to Gentoo.
Stage 3 does not include Xorg, so you must have done quite a bit more than just the stage 3 install.
If you used the liveCD kernel, its config can be read at /proc/config.gz. However its a fully modular one size fits all kernel.
When you make your own kernel, its a very bad place to start.
What command fails?
What error message do you get ?
_________________
Regards,
NeddySeagoon
Computer users fall into two groups:-
those that do backups
those that have never had a hard drive fail. |
|
| Back to top |
|
|
silverblue
n00b
Joined: 20 Oct 2006
Posts: 2
Location: Connecticut, USA
|
| Posted: Fri Oct 20, 2006 5:36 pm Post subject: |
|
|
Thanks Neddy!
Unfortunately the computer is at home and I am at work right now, but the message that I got was:
| Code: |
dlopen: /usr/lib/xorg/modules/extensions/libGLcore.so: undefined symbol: __glXLastContext
(EE) Failed to load /usr/lib/xorg/modules/extensions/libGLcore.so
(II) UnloadModule: "GLcore"
(EE) Failed to load module "GLcore" (loader failed, 7)
|
But from what I gather, I should be using the nVidia GLX libraries instead of the GLcore modules anyway (right?), which is covered under the nVidia guide... so I hope that will solve the problem.
_________________
---------
Silver Blue |
|
| Back to top |
|
|
NeddySeagoon
Administrator
Joined: 05 Jul 2003
Posts: 54585
Location: 56N 3W
|
| Posted: Fri Oct 20, 2006 5:57 pm Post subject: |
|
|
silverblue,
Run In the USE section, is opengl present ?
If not, edit /etc/make.conf, add it to your USE= there, then runso it takes effect.
_________________
Regards,
NeddySeagoon
Computer users fall into two groups:-
those that do backups
those that have never had a hard drive fail. |
|
| Back to top |
|
|
|
Kernel & Hardware
