SiS5597 et partition check

[Sintec16]

HEllo

I try since a small moment to install a gentoo on a HP Vectra. It is about P200 MMX with 92Mo of RAM.

The problem comes because the CD no boot it blocks on the instructions following one...

ide: Assuming 33Mhz system bus speed for PIO modes; override with idebus=xx
SIS5513: IDE controller on PCI bus 00 dev 09
PCI: No IRQ known for interrupt pin A of device 00:01.1. Please try using pci=biosirq
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SiS5597
ide0: BM-DMA at 0xfcf0-0xfcf7, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xfcf8-0xfcff, BIOS settings: hdc:pio, hdd:pio
hda: QUANTUM FIREBALL SE2.1A, ATA DISK drive
hdc: HITACHI CDR-8335, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14
ide0 at 0x170-0x177, 0x376 on irq 15
hda: 4124736 sectors (2112 MB) w/80KiB Cache, CHS=4092/16/63, UDMA(33)
hdc: ATAPI 24X CD-ROM drive, 128kB Cache, DMA
Uniform CD-ROM driver Revision: 3.12
ide-floppy driver 0.99b
Partition check:
hda:_

I think that problem is of in the kernel 2.4.18 and a superior...

Because I tried with various distributions (Mandrake, Debian, Astaro, RedHat) and I have the same problem.

The only versions which I was able to install it's Redhat 7 and a debian 2 ( Kernel 2.2.16 and 2.4.?? )

If somebody has an idea, a solution please Help me
_________________
Sintec16
Because C is a way of life...