unrstuart
n00b
Joined: 10 Dec 2007
Posts: 1
|
 Posted: Mon Dec 10, 2007 10:05 pm Post subject: Attansic L1 Gigabit driver giving intermittent problems |
 |
|
Every so often, my ethernet card apparently decides to stop accepting any commands from the kernel. A quick call to /etc/init.d/net.eth0 restart fixes this, but when I am not at my machine (and wanting to ssh into said machine), this isn't a possibility. I am using the experimental driver for the Attansic built-in network card, as it is the only networking driver support by my kernel. I have checked dmesg upon network failures, but nothing useful seems to be there. I've attached some (hopefully) helpful output. Any help would be greatly appreciated.
| Code: |
stuart@helix ~ $ uname -a
Linux helix 2.6.22-gentoo-r9 #6 SMP Fri Nov 2 17:40:43 PDT 2007 x86_64 Intel(R) Core(TM)2 CPU 6600 @ 2.40GHz GenuineIntel GNU/Linux
stuart@helix ~ $ /usr/sbin/lspci
00:00.0 Host bridge: Intel Corporation DRAM Controller (rev 02)
00:01.0 PCI bridge: Intel Corporation PCI Express Root Port (rev 02)
00:1a.0 USB Controller: Intel Corporation USB UHCI Controller #4 (rev 02)
00:1a.1 USB Controller: Intel Corporation USB UHCI Controller #5 (rev 02)
00:1a.2 USB Controller: Intel Corporation USB UHCI Controller #6 (rev 02)
00:1a.7 USB Controller: Intel Corporation USB2 EHCI Controller #2 (rev 02)
00:1b.0 Audio device: Intel Corporation HD Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation PCI Express Port 1 (rev 02)
00:1c.4 PCI bridge: Intel Corporation PCI Express Port 5 (rev 02)
00:1c.5 PCI bridge: Intel Corporation PCI Express Port 6 (rev 02)
00:1d.0 USB Controller: Intel Corporation USB UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation USB UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation USB UHCI Controller #3 (rev 02)
00:1d.7 USB Controller: Intel Corporation USB2 EHCI Controller #1 (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 92)
00:1f.0 ISA bridge: Intel Corporation LPC Interface Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 2 port SATA IDE Controller (rev 02)
00:1f.3 SMBus: Intel Corporation SMBus Controller (rev 02)
00:1f.5 IDE interface: Intel Corporation 2 port SATA IDE Controller (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation G80 [GeForce 8800 GTX] (rev a2)
02:00.0 Ethernet controller: Attansic Technology Corp. L1 Gigabit Ethernet Adapter (rev b0)
03:00.0 SATA controller: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 03)
03:00.1 IDE interface: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 03)
05:03.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev c0)
stuart@helix ~ $ /sbin/ifconfig
eth0 Link encap:Ethernet HWaddr 00:1B:FC:39:C9:AF
inet addr:169.237.118.209 Bcast:169.237.118.255 Mask:255.255.255.0
inet6 addr: fe80::21b:fcff:fe39:c9af/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5280 errors:0 dropped:0 overruns:0 frame:0
TX packets:4568 errors:0 dropped:0 overruns:0 carrier:2
collisions:0 txqueuelen:1000
RX bytes:5355279 (5.1 Mb) TX bytes:1095590 (1.0 Mb)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
stuart@helix ~ $ dmesg | tail
EXT3 FS on sda3, internal journal
nvidia: module license 'NVIDIA' taints kernel.
ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:01:00.0 to 64
NVRM: loading NVIDIA UNIX x86_64 Kernel Module 100.14.19 Wed Sep 12 14:08:38 PDT 2007
Adding 9775544k swap on /dev/sda2. Priority:-1 extents:1 across:9775544k
atl1 0000:02:00.0: eth0 link is up 100 Mbps full duplex
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
eth0: no IPv6 routers present
|
|
|
Networking & Security
