XavierGnu
n00b
Joined: 17 Apr 2007
Posts: 16
|
 Posted: Mon Jan 21, 2008 11:30 pm Post subject: Firewire DVD cannot automount? |
 |
|
Hi all,
I've installed automount following the manual on http://gentoo-wiki.com/HOWTO_Auto_mount_filesystems_(AUTOFS).
In fact, I just need it for USB and CD/DVD devices.
Thing is that it works fine with CDROM and USB sticks, but not with external Firewire DVD burner.
Here's the files:
(last part of dmesg)
| Code: |
Probing IDE interface ide1...
hdc: SAMSUNG CD-R/RW SW-240B, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 512KiB
hda: 156301488 sectors (80026 MB) w/8192KiB Cache, CHS=16383/255/63
hda: cache flushes supported
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 >
hdc: ATAPI 40X CD-ROM CD-R/RW drive, 8192kB Cache
Uniform CD-ROM driver Revision: 3.20
3ware Storage Controller device driver for Linux v1.26.02.002.
Fusion MPT base driver 3.04.05
Copyright (c) 1999-2007 LSI Logic Corporation
Fusion MPT SPI Host driver 3.04.05
ACPI: PCI Interrupt 0000:00:08.0[A] -> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10
ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[10] MMIO=[e7001000-e70017ff] Max Packet=[2048] IR/IT contexts=[4/4]
ieee1394: raw1394: /dev/raw1394 device initialized
usbmon: debugfs is not available
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
USB Universal Host Controller Interface driver v3.0
ACPI: PCI Interrupt 0000:00:07.2[D] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
uhci_hcd 0000:00:07.2: UHCI Host Controller
uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:07.2: irq 11, io base 0x0000d400
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ACPI: PCI Interrupt 0000:00:07.3[D] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
uhci_hcd 0000:00:07.3: UHCI Host Controller
uhci_hcd 0000:00:07.3: new USB bus registered, assigned bus number 2
uhci_hcd 0000:00:07.3: irq 11, io base 0x0000d800
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usblp
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 KBD port at 0x60,0x64 irq 1
mice: PS/2 mouse device common for all mice
device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.14 (Fri Jul 20 09:12:58 2007 UTC).
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 12
PCI: setting IRQ 12 as level-triggered
ACPI: PCI Interrupt 0000:00:07.5[C] -> Link [LNKC] -> GSI 12 (level, low) -> IRQ 12
PCI: Setting latency timer of device 0000:00:07.5 to 64
ieee1394: Host added: ID:BUS[0-00:1023] GUID[00004c0107003394]
ALSA device list:
#0: VIA 82C686A/B rev50 with VIA1612A at 0xdc00, irq 12
oprofile: using timer interrupt.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
ieee80211: 802.11 data/management/control stack, git-1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation <jketreno@linux.intel.com>
ieee80211_crypt: registered algorithm 'NULL'
ieee80211_crypt: registered algorithm 'WEP'
Using IPI No-Shortcut mode
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 280k freed
EXT3 FS on hda7, internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda10, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 393552k swap on /dev/hda6. Priority:-1 extents:1 across:393552k
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
eth0: no IPv6 routers present
usb 1-1: new full speed USB device using uhci_hcd and address 2
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access USB NAND FLASH DISK 2.00 PQ: 0 ANSI: 2
sd 0:0:0:0: [sda] 997376 512-byte hardware sectors (511 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 997376 512-byte hardware sectors (511 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: sda1
sd 0:0:0:0: [sda] Attached SCSI removable disk
sd 0:0:0:0: Attached scsi generic sg0 type 0
usb-storage: device scan complete
ieee1394: The root node is not cycle master capable; selecting a new root node and resetting...
ieee1394: Error parsing configrom for node 0-00:1023
ieee1394: Node changed: 0-00:1023 -> 0-01:1023
ieee1394: Node added: ID:BUS[0-00:1023] GUID[0030e00150009c01]
scsi1 : SBP-2 IEEE-1394
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
scsi 1:0:0:0: CD-ROM _NEC DVD_RW ND-3520AW 3.07 PQ: 0 ANSI: 0
sr0: scsi3-mmc drive: 48x/48x writer cd/rw xa/form2 cdda tray
sr 1:0:0:0: Attached scsi CD-ROM sr0
sr 1:0:0:0: Attached scsi generic sg1 type 5
ieee1394: Node changed: 0-01:1023 -> 0-00:1023
ieee1394: Node suspended: ID:BUS[0-00:1023] GUID[0030e00150009c01]
ieee1394: Error parsing configrom for node 0-00:1023
ieee1394: Node changed: 0-00:1023 -> 0-01:1023
ieee1394: Node resumed: ID:BUS[0-00:1023] GUID[0030e00150009c01]
scsi2 : SBP-2 IEEE-1394
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
scsi 2:0:0:0: CD-ROM _NEC DVD_RW ND-3520AW 3.07 PQ: 0 ANSI: 0
sr0: scsi3-mmc drive: 48x/48x writer cd/rw xa/form2 cdda tray
sr 2:0:0:0: Attached scsi CD-ROM sr0
sr 2:0:0:0: Attached scsi generic sg1 type 5
Clocksource tsc unstable (delta = 104742027 ns)
|
auto.auto
| Code: |
cdrom -fstype=iso9660,ro :/dev/cdrom
fw -fstype=iso9660,ro :/dev/sr0
|
auto.master:
| Code: |
# $Id: auto.master,v 1.3 2004/12/09 08:25:48 robbat2 Exp $
# Sample auto.master file
# Format of this file:
# mountpoint map options
# For details of the format look at autofs(8).
#/net /etc/autofs/auto.net
#/misc /etc/autofs/auto.misc
#/home /etc/autofs/auto.home
/mnt/auto /etc/autofs/auto.auto --timeout=5 --ghost
|
Symlinks
| Code: | | /mnt/cdrom to /mnt/auto/cdrom |
and | Code: | | /mnt/fw to /mnt/auto/fw |
created.
Manual mount of FireWire DVD works also fine from /dev/sr0.
Any clues?
_________________
'May the source be with you' |
|
Kernel & Hardware
