| View previous topic :: View next topic |
| Author |
Message |
unai001
n00b
Joined: 01 Feb 2008
Posts: 62
|
 Posted: Sat Feb 09, 2008 11:54 am Post subject: [SOLVED]Bluetooth problems |
 |
|
Hi, im trying to configure gentoo in my laptop, but i can't go over a problem:
I have followd the gentoo-wiki bluetooth mouse guide, but i can't connect my bluetooth mouse to the laptop, i have emerged bluez-utils & bluez-libs and they are correctly instaled, i modified the /etc/conf.d/bluetooth file according to the guide, restart the bluetooth /etc/init.d/bluetooth (also rebooted) and then i modprobed the modules as the guide says. The problem is that when i start the /etc/init.d/bluetooth it gives this messages:
| Code: | * Caching service dependencies ... [ ok ]
* Shutting down Bluetooth ...
* Stopping rfcomm ...
Can't open RFCOMM control socket: Protocol not supported [ !! ]
* Stopping hidd ... [ ok ]
* Stopping sdpd ... [ ok ]
* Stopping hcid ... [ ok ]
* Starting Bluetooth ...
* Starting hcid ... [ ok ]
* Starting sdpd ... [ !! ]
* Starting hidd ...
Can't open HIDP control socket: Protocol not supported [ !! ]
* Starting rfcomm ...
Can't open RFCOMM control socket: Protocol not supported [ ok ]
|
And when i run a hidd --search:
| Code: | Can't open HIDP control socket: Protocol not supported
|
What am i doing bad?
Last edited by unai001 on Sat Feb 09, 2008 8:17 pm; edited 1 time in total |
|
| Back to top |
|
 |
Voltago
Advocate
Joined: 02 Sep 2003
Posts: 2593
Location: userland
|
| Posted: Sat Feb 09, 2008 5:17 pm Post subject: |
|
|
First thing you should check is if your kernel supports the RFCOMM and HIDP profiles, i. e.
| Code: | CONFIG_BT_RFCOMM=m
CONFIG_BT_HIDP=m |
should be set in your kernel's .config file. Then make sure the appropriate modules are loaded (actually this should happen automatically on demand). |
|
| Back to top |
|
|
unai001
n00b
Joined: 01 Feb 2008
Posts: 62
|
| Posted: Sat Feb 09, 2008 8:16 pm Post subject: |
|
|
Ok, i solved it the problem was that the "bluetooth" and "hidp" modules werent being loaded, weird because i run "modprobe -v hci_usb bluetooth hidp l2cap
" as the guide suggested, but it didn't work, i had to modprobe bluetooth sn hidp separately :S
Thx |
|
| Back to top |
|
|
|
Kernel & Hardware
