snoeseven
n00b
Joined: 30 Jun 2007
Posts: 3
|
 Posted: Sun Oct 19, 2008 9:04 pm Post subject: wpa_supplicant authentication drop TX EAPOL? |
 |
|
Hey all.
Working on getting my laptop on my WPA network. I'm using the hostap drivers on a prism2 with updated firmware. I keep getting the following error when running wpa_supplicant when connecting to my WPA network:
| Quote: | EAPOL: txStart
WPA: drop TX EAPOL in non-IEEE 802.1X mode (type=1 len=0)
Authentication with 00:18:01:e7:19:7d timed out. |
I've searched the forums and google and it seems there is surprisingly little about that message. Relevant system output:
dmesg during startup:
| Quote: |
hostap_pci: Registered netdevice wifi0
wifi0: Original COR value: 0x0
prism2_hw_init: initialized in 196 ms
wifi0: NIC: id=0x8022 v1.0.0
wifi0: PRI: id=0x15 v1.1.1
wifi0: STA: id=0x1f v1.8.2
wifi0: Intersil Prism2.5 PCI: mem=0xf4006000, irq=18
wifi0: registered netdevice wlan0
|
/etc/conf.d/net:
| Quote: | modules=( "wpa_supplicant" )
wpa_supplicant_wlan0="-Dhostap"
config_wlan0=( "dhcp" ) |
/etc/wpa_supplicant/wpa_supplicant.conf
| Quote: | ctrl_interface=/var/run/wpa_supplicant
ctrl_interface_group=0
update_config=1
ap_scan=1
network={
ssid="foo"
key_mgmt=WPA-PSK
psk="foopsk"
priority=5
}
|
And here's the entirety of the wpa_supplicant output:
| Quote: |
Initializing interface 'wlan0' conf '/etc/wpa_supplicant/wpa_supplicant.conf' driver 'default' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant/wpa_supplicant.conf' -> '/etc/wpa_supplicant/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant/wpa_supplicant.conf'
ctrl_interface='/var/run/wpa_supplicant'
ctrl_interface_group='0' (DEPRECATED)
update_config=1
ap_scan=1
Line: 12 - start of a new network block
ssid - hexdump_ascii(len=7):
43 61 6c 61 64 61 6e foo
key_mgmt: 0x2
PSK (ASCII passphrase) - hexdump_ascii(len= : [REMOVED]
priority=5 (0x5)
PSK (from passphrase) - hexdump(len=32): [REMOVED]
Priority group 5
id=0 ssid='foo'
Initializing interface (2) 'wlan0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=22 WE(source)=18 enc_capa=0xf
capabilities: key_mgmt 0xf enc 0xf
Added alternative ifindex 3 (wifi0) for wireless events
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:02:8a:94:b5:92
wpa_driver_wext_set_wpa
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wpa_driver_wext_set_drop_unencrypted
Setting scan request: 0 sec 100000 usec
ctrl_interface_group=0
Added interface wlan0
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Trying to get current scan results first without requesting a new scan to speed up initial association
Received 851 bytes of scan results (6 BSSes)
Scan results: 6
Selecting BSS from priority group 5
0: 00:18:01:e7:19:7d ssid='foo' wpa_ie_len=24 rsn_ie_len=0 caps=0x11
selected based on WPA IE
Trying to associate with 00:18:01:e7:19:7d (SSID='foo' freq=2412 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x1
WPA: using IEEE 802.11i/D3.0
WPA: Selected cipher suites: group 16 pairwise 16 key_mgmt 2 proto 1
WPA: set AP WPA IE - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 04 01 00 00 50 f2 04 01 00 00 50 f2 02
WPA: clearing AP RSN IE
WPA: using GTK CCMP
WPA: using PTK CCMP
WPA: using KEY_MGMT WPA-PSK
WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 04 01 00 00 50 f2 04 01 00 00 50 f2 02
No keys have been configured - skip key clearing
wpa_driver_wext_set_drop_unencrypted
State: SCANNING -> ASSOCIATING
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
wpa_driver_wext_associate
Setting authentication timeout: 10 sec 0 usec
EAPOL: External notification - EAP success=0
EAPOL: External notification - EAP fail=0
EAPOL: External notification - portControl=Auto
RTM_NEWLINK: operstate=0 ifi_flags=0x1002 ()
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK: operstate=0 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wifi0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
Added BSSID 00:18:01:e7:19:7d into blacklist
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
State: ASSOCIATING -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wifi0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b04 len=12
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b1a len=15
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:18:01:e7:19:7d
State: DISCONNECTED -> ASSOCIATED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Associated to a new BSS: BSSID=00:18:01:e7:19:7d
No keys have been configured - skip key clearing
Associated with 00:18:01:e7:19:7d
WPA: Association event - clear replay counter
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
EAPOL: External notification - portEnabled=1
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: SUPP_BE entering state IDLE
Setting authentication timeout: 10 sec 0 usec
Cancelling scan request
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wifi0' added
EAPOL: startWhen --> 0
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: txStart
WPA: drop TX EAPOL in non-IEEE 802.1X mode (type=1 len=0)
Authentication with 00:18:01:e7:19:7d timed out.
|
While wpa_supplicant is running I get the following in /var/log/messages:
| Quote: |
Oct 19 08:59:21 bar wifi0: LinkStatus=2 (Disconnected)
Oct 19 08:59:21 bar wifi0: LinkStatus: BSSID=00:18:01:e7:19:7d
Oct 19 08:59:21 bar wifi0: LinkStatus=2 (Disconnected)
Oct 19 08:59:21 bar wifi0: LinkStatus: BSSID=44:44:44:44:44:44
Oct 19 08:59:21 bar wifi0: LinkStatus=2 (Disconnected)
Oct 19 08:59:21 bar wifi0: LinkStatus: BSSID=44:44:44:44:44:44
Oct 19 08:59:21 bar wlan0: Trying to join BSSID 00:18:01:e7:19:7d
Oct 19 08:59:21 bar wifi0: LinkStatus=1 (Connected)
Oct 19 08:59:21 bar wifi0: LinkStatus: BSSID=00:18:01:e7:19:7d |
Any ideas on this one? Thanks in advance. |
|
Networking & Security
