flammenflitzer
Advocate
Joined: 25 Nov 2003
Posts: 3537
Location: Berlin
|
 Posted: Mon Jul 20, 2009 4:37 pm Post subject: hama card reader 19in1 |
 |
|
Hallo
Ich habe einen hama card reader 19in1 mit einer eingesteckten SD Card angeschlossen. Wie bekomme ich es hin, das hal in kde das Gerät an den Gerätemanager übergibt?
dmesg
| Code: | Initializing USB Mass Storage driver...
scsi8 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
scsi 8:0:0:0: Direct-Access HP Photosmart M540 1.00 PQ: 0 ANSI: 0 CCS
sd 8:0:0:0: [sde] 1950721 512-byte hardware sectors: (998 MB/952 MiB)
sd 8:0:0:0: [sde] Write Protect is off
sd 8:0:0:0: [sde] Mode Sense: 00 00 00 00
sd 8:0:0:0: [sde] Assuming drive cache: write through
sd 8:0:0:0: [sde] 1950721 512-byte hardware sectors: (998 MB/952 MiB)
sd 8:0:0:0: [sde] Write Protect is off
sd 8:0:0:0: [sde] Mode Sense: 00 00 00 00
sd 8:0:0:0: [sde] Assuming drive cache: write through
sde: sde1
sd 8:0:0:0: [sde] Attached SCSI removable disk
sd 8:0:0:0: Attached scsi generic sg8 type 0
usb-storage: device scan complete
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Recorded entity not found
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
sd 8:0:0:0: [sde] Unhandled sense code
sd 8:0:0:0: [sde] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sd 8:0:0:0: [sde] Sense Key : Medium Error [current]
sd 8:0:0:0: [sde] Add. Sense: Unrecovered read error
end_request: I/O error, dev sde, sector 1950720
Buffer I/O error on device sde, logical block 1950720
usb 2-8: USB disconnect, address 3
usb 1-8: new high speed USB device using ehci_hcd and address 5
usb 1-8: configuration #1 chosen from 1 choice
scsi9 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 5
usb-storage: waiting for device to settle before scanning
scsi 9:0:0:0: Direct-Access Hama CF Card Reader 9317 PQ: 0 ANSI: 0
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
sd 9:0:0:0: [sde] Attached SCSI removable disk
sd 9:0:0:0: Attached scsi generic sg8 type 0
scsi 9:0:0:1: Direct-Access Hama SM Card Reader 9317 PQ: 0 ANSI: 0
sd 9:0:0:1: [sdf] Attached SCSI removable disk
sd 9:0:0:1: Attached scsi generic sg9 type 0
scsi 9:0:0:2: Direct-Access Hama SD Card Reader 9317 PQ: 0 ANSI: 0
sd 9:0:0:2: [sdg] Attached SCSI removable disk
sd 9:0:0:2: Attached scsi generic sg10 type 0
scsi 9:0:0:3: Direct-Access Hama MS Card Reader 9317 PQ: 0 ANSI: 0
sd 9:0:0:3: [sdh] Attached SCSI removable disk
sd 9:0:0:3: Attached scsi generic sg11 type 0
usb-storage: device scan complete
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
sd 9:0:0:2: Device offlined - not ready after error recovery
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
sd 9:0:0:1: Device offlined - not ready after error recovery
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
sd 9:0:0:3: Device offlined - not ready after error recovery
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
usb 1-8: reset high speed USB device using ehci_hcd and address 5
sd 9:0:0:0: Device offlined - not ready after error recovery |
Muß ich etwas aus /usr/share/hal/fdi/policy nach /etc/hal/.. kopieren? |
|
Deutsches Forum (German)
