USB Palm-PDA (Tungsten E) Syncing -- Your Kernel options?

Winsmith

Hi,

I'm trying to get my Tungsten E to sync with JPilot, but usb.c: USB device 13 (vend/prod 0x830/0x60) is not claimed by any active driver. (says dmesg)

I figure I'm missing one or two kernel modules or options. So here's my questions:

1) I'm using Kernel 2.4.24 at the moment. Would it be wise to migrate to Kernel 2.6 only to tackle this specific problem? Is there a chance that it would work better in 2.6?
2) Either way, could you post the options you have enabled in your Kernel that made the synchronization work? I'd be most obliged :wink:

Thanks,
-winsmith

foton2 · Posted: Wed Apr 07, 2004 12:43 pm Post subject:

tcaptain · n00b Joined: 24 Feb 2004 Posts: 23

I'm using 2.6 with the options above (except I think I have them IN my kernel rather than modules) and I have a tungsten E. JPilot works great so far...but KPilot doesn't (no biggie).

Winsmith · Posted: Wed Apr 07, 2004 3:42 pm Post subject:

Thanks! I'll upgrade then. Shouldn't be too much of a compatibility issue with my system, should it?

foton2 · Posted: Wed Apr 07, 2004 5:58 pm Post subject:

No, it was upgrade with no problems in my case.
good luck.

_________________
Pentium4 2.4Ghz 533Mhz, Intel® Desktop Board D845GEBV2 + LAN, 768MB DDR 266Mhz RAM, 80GB Seagate Barracuda 7200.7, NVIDIA GeForce4 MX 440, SB Live! 5.1, TEAC CD-552E, TEAC DW-548D, Packard Bell 1512SL Monitor, HP DeskJet 640C, Opti UPS PowerPS 800ps.