View previous topic :: View next topic |
Author |
Message |
topale n00b
![n00b n00b](/images/ranks/rank_rect_0.gif)
Joined: 27 Feb 2010 Posts: 6
|
Posted: Sat Feb 27, 2010 9:33 pm Post subject: [Ethernet] Automatiser le démarrage du module [résolu] |
|
|
Bonjour,
Ma carte ethernet est gérée par le module tg3
Code: | Ethernet controller: Broadcom Corporation NetLink BCM57780 Gigabit Ethernet PCIe (rev 01) |
J'ai compilé les drivers en module
Code: |
CONFIG_BROADCOM_PHY=m
CONFIG_TIGON3=m |
Le soucis c'est que pour faire fonctionner ma carte, je suis obligé de tapper à chaque démarage
Code: |
modprobe -r tg3
modprobe broadcom
modprobe tg3
|
A priori ceci viendrait du fait que le pilote tg3 se charge avant broadcom.
Existe-t-il un moyen d'automatiser cette connexion sans avoir a tapper ces commandes a chaque boot?
Merci
Last edited by topale on Sun Feb 28, 2010 12:21 am; edited 1 time in total |
|
Back to top |
|
![](templates/gentoo/images/spacer.gif) |
boozo Advocate
![Advocate Advocate](/images/ranks/rank-G-1-advocate.gif)
![](images/avatars/83658268945e337605eec8.gif)
Joined: 01 Jul 2004 Posts: 3193
|
|
Back to top |
|
![](templates/gentoo/images/spacer.gif) |
topale n00b
![n00b n00b](/images/ranks/rank_rect_0.gif)
Joined: 27 Feb 2010 Posts: 6
|
Posted: Sun Feb 28, 2010 12:21 am Post subject: |
|
|
Salut,
Merci pour ton aide.
J'avais un peu tout essayé sauf ca.
J'ai rajouté broadcom et tg3 dans les modules et blacklisté tg3 dans blacklist.conf
Et maintenant tout roule!! |
|
Back to top |
|
![](templates/gentoo/images/spacer.gif) |
|