| View previous topic :: View next topic |
| Author |
Message |
afa_guru
n00b
Joined: 02 Dec 2006
Posts: 5
|
 Posted: Mon Jul 19, 2010 9:12 pm Post subject: Install CD USB error messages |
 |
|
Hi,
I'm trying to install a fresh gentoo on my new laptop, but I have an annoying problem. Three times a second a line is written to the terminal, making it very difficult to read/write commands and getting the installation done: | Code: | | hub 1-1:1.0: unable to enumerate USB device on port 2 |
Is there a way to disable this usb debug message or make syslog-ng catch it?
I also thought about using ssh, but my network adaprots (wired: 88e8059, wireloss: ar9285) don't seem to be supported by the latest installation cd's kernel (2.6.31).
Any suggestions would be great. Thanks! |
|
| Back to top |
|
 |
DONAHUE
Watchman
Joined: 09 Dec 2006
Posts: 7651
Location: Goose Creek SC
|
| Posted: Tue Jul 20, 2010 12:31 am Post subject: |
|
|
boot cd, at boot prompt Assuming you can do without usb
Else use the better install cd, System Rescue CD , booted to a network connection, a GUI, and firefox open to the gentoo handbook next to the terminal window.
If you can't do a wired network, you will be best served by booting a very current livecd from another distro, ubuntu or knoppix recommended, and using that as the install platform instead of the minimal cd. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Installing Gentoo
