| View previous topic :: View next topic |
| Author |
Message |
Cr0t
l33t
Joined: 27 Apr 2002
Posts: 945
Location: USA
|
 Posted: Sat Dec 31, 2011 11:23 pm Post subject: bond0 speed |
 |
|
| Code: | 18:23:04^root@ninapie:/tmp > cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: load balancing (round-robin)
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Speed: 10 Mbps
Duplex: half
Link Failure Count: 0
Permanent HW addr: 00:50:8d:bb:e6:16
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 10 Mbps
Duplex: half
Link Failure Count: 0
Permanent HW addr: 00:50:8d:bb:e6:17
Slave queue ID: 0
18:23:09^root@ninapie:/tmp > mii-tool
eth0: negotiated 1000baseT-HD flow-control, link ok
eth1: negotiated 1000baseT-HD flow-control, link ok
18:23:11^root@ninapie:/tmp > mii-tool bond0
bond0: 10 Mbit, half duplex, link ok
18:23:13^root@ninapie:/tmp > |
10mbps ? Welll that is weird.
I get full speed, but I don't think I ever saw that.
_________________
cya |
|
| Back to top |
|
 |
Princess Nell
l33t
Joined: 15 Apr 2005
Posts: 927
|
| Posted: Sun Jan 01, 2012 10:14 pm Post subject: |
|
|
| In my experience, none of the tools, and that includes snmp, give correct values for bonded devices. The only reliable way to confirm bond speed is to run a transfer test and look at the ifconfig RX/TX fields before and after. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Networking & Security
