| View previous topic :: View next topic |
| Author |
Message |
aia
n00b
Joined: 16 Sep 2012
Posts: 18
|
 Posted: Sat Jan 05, 2013 7:12 pm Post subject: [SOLVED]Calling ioctl() to re-read partition table! |
 |
|
Hi all,
I try to install Gentoo Minimal Installation "install-x86-minimal-<20121213>.iso" in Virtual Box version 4.2.4 with virtual memory 1GB,virtual hard disk 60GB.
I was in the step where i tried to setup my disk. I used the fdisk command and i followed all the instructions but when i typed "w" for save all the changes in my hard disk i got the below alert.
| Code: |
The partition table has been altered!
Calling ioctl() to re-read partition table.
Syncing disks
|
I did the same process, (setup disk), two times, for be completely sure with the output,but also i got the same result.
I searched in the forum and i found this post http://forums-lb.gentoo.org/viewtopic-t-143073-start-0.html
but does not looks like to be the same with mine. We have same only the first line from the output.
Can anyone knows why i got this message. I appreciate any idea for my own solution.
Thanks!
Last edited by aia on Sat Jan 05, 2013 8:43 pm; edited 1 time in total |
|
| Back to top |
|
 |
NeddySeagoon
Administrator
Joined: 05 Jul 2003
Posts: 54586
Location: 56N 3W
|
| Posted: Sat Jan 05, 2013 7:49 pm Post subject: |
|
|
aia,
Those messages are for information only - there is no error.
Sometimes you get the error ... kernel still uses the old partition table!
Which forces a reboot.
Everything is OK for you - continue with your install.
_________________
Regards,
NeddySeagoon
Computer users fall into two groups:-
those that do backups
those that have never had a hard drive fail. |
|
| Back to top |
|
|
aia
n00b
Joined: 16 Sep 2012
Posts: 18
|
| Posted: Sat Jan 05, 2013 8:43 pm Post subject: |
|
|
NeddySeagoon thanks for your time.
So all good! |
|
| Back to top |
|
|
|
Installing Gentoo
