| View previous topic :: View next topic |
| Author |
Message |
Lasitus
Apprentice
Joined: 05 Oct 2002
Posts: 188
Location: Orlando, FL
|
 Posted: Sat Feb 02, 2013 10:05 pm Post subject: Installing as guest on Hyper-v client |
 |
|
I am trying to get a working setup on hyper-v client running on Windows 8 (I wish it could be the other way around, but alas, linux runs well in a VM and games do not.) Anyway, I have tried multiple kernel configurations all using gentoo-sources.
1. A kernel manually configured. This one boots, but I can't get networking to function. The only drivers I know of are under:
| Code: | | Device Drivers ---> Microsoft Hyper-V guest support ---> Microsoft Hyper-V client drivers ---> Microsoft Hyper-V Utilities driver |
- The boot CD works fine, so I know it should work in my current virtual HW configuration.
- Note: This is a 64 bit install.
- ifconfig -a just shows the loopback
- I have tried the hyper-v stuff as a module and built in. A guide I read said to make sure you compiled them as a module for some reason... any insight on that? Right now I am preferring compiled in, since I know it is loaded.
- I tried installing Intel(R) PRO/1000 PCI-Express Gigabit Ethernet support into the kernel (I have an intel 82579 in the host computer)
2. A genkernel kernel. This one doesn't even boot. It complains about root and can't mount it. I also tried customizing it, to no avail.
lspci doesn't show an ethernet adapter for either my boot or the live cd...
Any ideas? |
|
| Back to top |
|
 |
Lasitus
Apprentice
Joined: 05 Oct 2002
Posts: 188
Location: Orlando, FL
|
| Posted: Sun Feb 03, 2013 3:07 pm Post subject: |
|
|
Well, apparently, I was being stupid... I figured it out. I was thinking the hyper-v driver was all-inclusive and all of the guides out there said to look under Staging Drivers (which this was moved out of) I looked under:
Device Drivers ---> Network device support ---> Microsoft Hyper-V virtual network driver
and found the network driver. (can't believe I didn't see that yesterday.) |
|
| Back to top |
|
|
ShiroiKuma
n00b
Joined: 09 Nov 2012
Posts: 40
Location: Japan
|
| Posted: Sun Mar 03, 2013 12:25 pm Post subject: |
|
|
Would you be able to share your .config for the working kernel?
I'm trying Gentoo under Windows 8 Client Hyper-V and my install keeps hanging on booting up just after hv_vmbus loads at around 0.24, then nothing until around 60.4 and I get a warning "rcu_sched_state detected stalls on cpu".
Using a LiveCD to check the partition, I don't even have anything in /var/log/dmesg (it doesn't even exist), so that makes this even harder to debug |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Installing Gentoo
