Gentoo Forums
Gentoo Forums
Gentoo Forums
Quick Search: in
wireless card not detected
View unanswered posts
View posts from last 24 hours

 
Reply to topic    Gentoo Forums Forum Index Networking & Security
View previous topic :: View next topic  
Author Message
enrico68
Apprentice
Apprentice


Joined: 21 Oct 2016
Posts: 216

PostPosted: Thu Dec 26, 2024 5:02 pm    Post subject: wireless card not detected Reply with quote

Hello forum,

I start by saying that I have never had these many issues installing Gentoo on a PC or laptop. Xorg is not working and there is no wireless card detected...but let's start with one issue at a time.

When I boot into my new install and run
Code:
ip link

I get enp0s31f6, which is my wired card, and lo:. No wireless card...

If I run
Code:
ip link


1: lo

2: enp0s31f6

3. sit0@none

I added the firmware for the wifi by going into CONFIG_EXTRA_FIRMWARE, after running
Code:
dmesg | grep firmware
with the Gentoo LiveCD. I therefore added

Quote:
iwlwifi-ma-b0-gf-a0-89.ucode
in the kernel. but, when running
Code:
dmesg | grep firmware
in the new booted system, all I see is the 1915 firmware, and there is no mention of the iwlwifi which I expected to see. I also added the firmware for bluetooth support, and for sound, and I do not see either.

I have installed iwd following the iwd Gentoo wiki, but it cannot function with no firmware.

So, like I said, let's start with one issue at a time. I am putting a lot of effort and hours into this, but I am not going anywhere...next will be Xorg (I cannot startx), and sound...

Let's see if a patient helping hand is able to get me out of this mess...like I said, one step at a time, until I can finally have a working Gentoo...
Back to top
View user's profile Send private message
Zucca
Moderator
Moderator


Joined: 14 Jun 2007
Posts: 3782
Location: Rasi, Finland

PostPosted: Thu Dec 26, 2024 6:08 pm    Post subject: Re: wireless card not detected Reply with quote

enrico68 wrote:
but, when running
Code:
dmesg | grep firmware
in the new booted system, all I see is the 1915 firmware, and there is no mention of the iwlwifi which I expected to see.
Please paste the output of that command.
Also output of lspci -k could help, and zfgrep IWL /proc/config.gz too.
... finally lsmod could show us if the module for your network device is loaded.
_________________
..: Zucca :..

My gentoo installs:
init=/sbin/openrc-init
-systemd -logind -elogind seatd

Quote:
I am NaN! I am a man!
Back to top
View user's profile Send private message
enrico68
Apprentice
Apprentice


Joined: 21 Oct 2016
Posts: 216

PostPosted: Fri Dec 27, 2024 3:14 pm    Post subject: Reply with quote

Hello Zucca:

Here is the info you requested. As I do not have video capability, I could not copy/paste and I had to type all the below, as my Gentoo installation has only a console with a prompt; hopefully I did not make any mistakes...

Code:
dmesg | grep firmware


loading firmware i915/mtl_dmc.bin
i915 0000:00:02.0 [drm] Finished loading DMC firmware i915/mtl_dmc.bin (v2.23)
Loading firmware i915/mtl_guc_70.bin
Loading firmware i915/mtl_guc_70.bin
Loading firmware i915 /mtl_huc_gsc.bin
1915 0000:00:02:o [drm] *ERROR* GT1: GSC firmware i915/mtl_gsc_1.bin: fetch failed -NOENT
1915 0000.00.02.0 [drm] GT1: GSC firmware can be downloaded from https:// git/kernel.org/pu/src/linux/kernel/git/firmware/inux-firmware.git/tree/1915
1915 0000.00.02.0 [drm] GT0: GUC firmware i915/mtl_guc_70.bin version 70.36.0
1915 0000.00.02.0 [drm] GT1: GUC firmware i915/mtl_guc_70.bin version 70.36.0
i915 0000.00.02.0 [drm] GT1 HuC firmware i915/mtl_huc_gsc.bin version 8.5.4
psmouse serio1: trackpoint : Elan Trackpoint firmware : 0x0, buttons: 3x3
loading firmware: regulatory.db
Loading firmware: regulatory.db.p7s





Code:
lspci -k


00.00.0 Host bridge: Intel Corporation Device 7d02 (rev 04)
00.02.0 VGA copatible controller: Intel Corporation MeteorLake-P [Intel Graphics] (rev04)
Subsystem Lenovo Device 2327
Kernel Driver in use: i915
00.04.0 Signal processing controller: Intel Corporation Meteor-Lake-P Dynamic Tuning Technology (rev 04)
Subsystem Lenovo Device 2327
00.06.0 PCI bridge: Intel Corporation Device 7e4d (rev 20)
Subsystem Lenovo Device 2327
00.06.1 PCI bridge Intel Corporation Device 7eca (rev 10)
Subsystem Lenovo Device 2327
Kernel Driver in use: pcieport
00.07.0 PCI bridge: Intel Corporation Meteor Lake -P Thunderbolt 4 PCI Express Root Port #0 (rev02)
Subsystem LenovoDevice 2327
Kernel Driver in use: pcieport
00.07.2 PCI bridge: Intel Corporation Meteor Lake -P Thunderbolt 4 PCI Express Root Port #2 (rev02)
Subsystem LenovoDevice 2327
Kernel Driver in use: pcieport
00.0a.0 SignalProcessing Controller: Intel Corporation Meteor Lake-P Platform Monitoring Technology (rev01)
Subsystem LenovoDevice 2327
00.0b.0 Processing accelerators: Intel Corporation Meteor Lake NPU (rev04)
Subsystem LenovoDevice 2327
00.0d.0 USB controller: Intel Corporation Meteor Lake -P Thunderbolt 4 USB controller (rev02)
Subsystem LenovoDevice 2327
00.0d.2 USB controller: Intel Corporation Meteor Lake -P Thunderbolt 4 NHI #0 (rev02)
Subsystem LenovoDevice 2327
Kernel Driver in use: thunderbolt
00.0d.3 USB controller: Intel Corporation Meteor Lake -P Thunderbolt 4 NHI #1 (rev02)
Subsystem LenovoDevice 2327
Kernel Driver in use: thunderbolt
00.14.0 USB controller: Intel Corporation Meteor Lake -P USB 3.2 Gen 2x1 xHCI Host Controller (rev20)
Subsystem LenovoDevice 2327
Kernel Driver in use: xhci_hcd
00.14.2 RAM memory: Intel Corporation Device 7e7f (rev20)
Subsystem LenovoDevice 2327
00.14.3 Network Controller: Intel Corporation Meteor Lake PCH CNVi WiFi (rev20)
Subsystem: Intel Corporation Device 0090
00.15.0 Serial bus controller: Intel Corporation Meteor Lake -P Serial IO I2C Controller #0 (rev20)
Subsystem LenovoDevice 2327
Kernel Driver in use: intel-lpss
00.16.0 Communication controller: Intel Corporation Meteor Lake -P CSME HECI #1 (rev20)
Subsystem LenovoDevice 2327
Kernel Driver in use: mei_me
00.16.3 Serial Controller: Intel Corporation Meteor Lake -P Keyboard and Text (KT) Redirection (rev20)
Subsystem LenovoDevice 2327
Kernel Driver in use: serial
00.1c.0 PCI bridge: Intel Corporation Device 7e38 (rev20)
Subsystem LenovoDevice 2327
Kernel driver in use: pcieport
00.1f.0 ISA bridge: Intel Corporation Device 7e03 (rev20)
Subsystem LenovoDevice 2327
00.1f.3 Audio device: Intel Corporation Meteor Lake -P Audio Controller (rev20)
Subsystem LenovoDevice 2327
Kernel modules: snd_sof_pci_intel_mtl
00.1f.4 SMBus: Intel Corporation Meteor Lake -P SMBus Controller (rev20)
00.1f.5 Serial Bus Controller: Intel Corporation Meteor Lake -P SPI Controller (rev20)
Subsystem LenovoDevice 2327
00.1f.6 Ethernet Controller: Intel Corporation Device 550a (rev20)
Subsystem LenovoDevice 2327
Kernel driver in use: e1000e
04.00.0 Non-Volatile memory controller: KIOXIA Corporation NVMe SSD Controller XG8 (rev01)
Subsystem: Kioxia Corporation Device 001
Kernel driver in use: nvme


Code:
zfgrep IWL /proc/config.gz


no such file or directory

Code:
lsmod


Module Size Used by
cfg80211 0
snd_sof_pci_intel_mtl 0
snd_sof_intel_hda_generic 1 snd_sof_pci_intel_mtl
snd_sof_intel_hda_common 2 snd_sof_pci_intel_-mtl, snd_sof_intel_hda_generic
snd_sof_pci 2 snd_sof_pci_intel_-mtl, snd_sof_intel_hda_generic
snd_sof 4 snd_sof_pci_intel_mtl,snd_sof_pci, sof_intel_hda_common, snd_sof_intel_hda_generic
snd_sof_utils 1 snd_sof
snd_sof_xtensa_dsp 1 snd_sof_intel_hda_generic
snd_soc_core 1 snd_sof_
snd_compress 1 snd_soc_core
x86_pkg_temp_thermal 0
snd_soc_acpi_intel_match 2 snd_sof_pci_intel_mtl, snd_sof_intel_hda_generic
snd_soc_acpi snd_soc_acpi_intel_match, snd_sof_intel_hda_generic
Back to top
View user's profile Send private message
pietinger
Moderator
Moderator


Joined: 17 Oct 2006
Posts: 5259
Location: Bavaria

PostPosted: Fri Dec 27, 2024 4:05 pm    Post subject: Reply with quote

Hello Enrico,

because I'm an old man and sometimes get things mixed up I don't know if I've given you the following links before. If not, please read everything in this order - you definitely need wgetpaste:

* https://wiki.gentoo.org/wiki/User:Pietinger/Overview_of_System_Information

...and DO number 2 of this chapter:

* https://wiki.gentoo.org/wiki/User:Pietinger/Tutorials/Manual_kernel_configuration#Before_you_start ->

Yes, it MUST be the LIVE-CD (and not the minimal-CD)

... and later read it completely:

* https://wiki.gentoo.org/wiki/User:Pietinger/Tutorials/Manual_kernel_configuration

... including all links ... ;-)

Check if you have a typo somewhere ... and ... if you need more help, please provide us your kernel .config and all 3 files mentionend in https://wiki.gentoo.org/wiki/User:Pietinger/Overview_of_System_Information

Perhaps it would make more sense if we took care of your xorg problem first, so that you have a graphical interface. Which WM or DE do you want to use?

We can see many other answers to questions - such as whether you are using systemd or OpenRC - from the data you send us via wgetpaste (e.g. in ‘emerge --info’).
_________________
https://wiki.gentoo.org/wiki/User:Pietinger
Back to top
View user's profile Send private message
Display posts from previous:   
Reply to topic    Gentoo Forums Forum Index Networking & Security All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum